说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 孔隙尺寸
1.
Pore size evolution of granular ore media during heap leaching
堆浸过程中矿岩散体粒间孔隙尺寸的演化规律
2.
The pore diameter was very tiny so that it could prevent hydrotropic solution entering into the pore.
二是孔隙的尺寸很小,水溶液不能渗入到孔隙,不能到达基体。
3.
In general, smaller grain size and greater angularity tend to increase the porosity while an increase in range of particle size tends to decrease porosity.
通常,颗粒越小曲率越大孔隙度越大,而当颗粒尺寸增大时孔隙度会减
4.
Influence of the Air-Hole Size and Doped Dielectric Cylinders Size in Cladding on Photonic Crystal Fiber
光子晶体光纤包层中气孔和掺杂介质柱尺寸对光纤带隙特性的影响
5.
The fixing holes of light rack should comply with those of lamp seat.
灯脚固定孔尺寸、置以灯座实际尺寸为准。
6.
Calculating the Geometrical Dimension of the Alternate Gear Driver by Making Use of Top-gap;
利用顶隙计算变位齿轮传动几何尺寸
7.
That can pass through a given pore size.
可滤过的能通过一给定微孔尺寸的
8.
Types and dimension for coupling bores and their connection
GB/T3852-1997联轴器轴孔和联结型式与尺寸
9.
A twist drill is designed to drill a hole which has a particular size.
麻花钻用来钻削具有一定尺寸的孔。
10.
Analysis of calculation of expanded size of punched hole and compression punching type;
浅析抽孔、压缩抽型的展开尺寸计算
11.
Drill jig size calculation of the double inclined holes in the handle of YT 24 rock drill
YT24型凿岩机柄体双斜孔钻模尺寸计算
12.
Investigation on turbulent flow through porous media based on a pore-network model
基于孔隙尺度网络模型的多孔介质内湍流流动
13.
A Study on the Representative Elementary Volume of Fractured Rock Masses and the Size Effects of Mechanical Properties;
裂隙岩体表征单元体及力学特性尺寸效应研究
14.
Vugs and fractures are highly variable in size and in distribution.
岩穴与裂缝在孔的尺寸和孔分布上变化不一。
15.
Frequency of the wide-band sandwich transducer with single hole in relation of the hole's size
穿单孔换能器的频率与孔尺寸间的关系研究
16.
The Control of Cylinder Cover Spring Holder Hole Cutting tool and Sinks the Hole Depth Size
气缸盖弹簧座孔刀具与沉孔深度尺寸的控制
17.
Continuous forms used for information processing--Sizes and feed holes
GB/T4873-1985信息处理用连续格式纸尺寸和输送孔
18.
Information processing--Cores perforated paper tape for information interchange--Dimensions
GB/T3237-1982信息处理交换用穿孔纸带的盘心尺寸