1.
generating line
【数】母线, 生产线
2.
CONNECT A JUMPER WIRE BETWEEN CCD BUS AND CCD BUS (−), CAB CAVITIES 5 AND 2
在ＣＣＤ母线和ＣＣＤ母线(−)、ＣＡＢ槽５和２之间连短接线。
3.
Application of REB500 Busbar Protection in Complex Busbar Connection;
REB500型母线保护在复杂母线接线型式上的应用
4.
double generator of a ruled surface
直纹曲面的二重母线
5.
Body Control Module CCD Bus (+)
车体控制模组ccd母线（+）
6.
REPAIR OPEN CCD BUS CKT
修理断开的ＣＣＤ母线电路＊
7.
cut a female screw thread with a tap.
用活栓切一条螺母线。
8.
CCD BUS (+/-) CIRCUITS-PCM OUTPUTS
CCD母线(+/-)电路-PCM输出
9.
indoor and outdoor bus bar bushing
户内外母线式穿墙套管
10.
Copper or aluminum and its alloy bus bars for electrical purposes--Part 2: Copper bus bar
GB5585.2-1985电工用铜、铝及其合金母线第2部分:铜母线
11.
Copper or aluminum and its alloy bus bars for electrical purposes--Part 3: Aluminum bus bar
GB5585.3-1985电工用铜、铝及其合金母线第3部分:铝母线
12.
Study on the Adaptive Operational Mode of Double Bus in Bus Protection
母线保护中双母线运行方式的自适应研究
13.
Single-bus Three-section Connection Mode Used for 10kV Distribution System
用于10kV配电的单母线三分段接线方式
14.
The Research of On-line Theoretical Computation of Line-loss and Analysis of Bus Equilibrium;
理论线损在线计算与母线平衡分析的研究
15.
Through thedesign and analysis, a design scheme of the bus circuit detecting the third rail voltage is presented.
通过对检测母线电压的母线电路的设计和分析,提出了检测第三轨电压的母线电路设计方案。
16.
USING AN OHMMETER MEASURE BETWEEN CCD BUS CKTS AND CCD BUS CKTS.
用欧姆表在ＣＣＤ母线（+）电路与ＣＣＤ母线电路之间测量。
17.
Any CCD bus intermittent failure (may be viewed in stored codes once bus is repaired)
任何ＣＣＤ母线间断错误（可能会在修理母线时从存储码中看到）
18.
No Bus Bias – The bus system has lost connection with all modules that provide bias.
无母线偏压 ‐母线系统已失去与提供偏压模组的联系