1.
The Research of Integrated Adjustment Method of Injection Production System in Xinzhan Oilfield
新站油田注采系统综合调整方法研究
2.
Research on Reasonable Injection-production System in Ultra-low Permeable Oilfield of Jilin
吉林特低渗透油田合理注采系统研究
3.
Numerical Simulation Research on Injection-production System Adjustment of Block Chao-55
朝55区块注采系统调整数值模拟研究
4.
Sazhong Zone Injection-production System and the Potential for Adjustment Method;
萨中开发区注采系统调整潜力及方法研究
5.
Research on the Remaining Oil Tapping Potential and Water Flooding Regime Adjustment in East of Xing 1～2 Block;
杏1～2区东部剩余油挖潜及注采系统调整研究
6.
The Overall System Adjustment Research of High Water Cut Stage of Niuxintuo Petroleum Reservoir
牛心坨油层高含水期注采系统综合调整研究
7.
off-tract injection system
开采区外的注入系统
8.
A new method of research on injection-production pressure system and reasonable injection-production ratio
注采压力系统及合理注采比研究的一种方法
9.
The Study on the Technology of Sewage Treatment in the Eighth Factory of Oil Exploitation;
采油八厂油田注水、水处理系统技术研究
10.
Advantages and issues of sharing grounding in distributing electricity system;
配电系统采用共用接地的优点及应注意的问题
11.
Design of Indoor Testing System for Separate Layer Steam Injection
热采分层注汽室内模拟试验系统的设计
12.
Grouting Parameters Acquisition and Network Issue System Based on PPI Protocol
基于PPI协议的注浆参数采集和网络发布系统
13.
Establishment and Evaluation of Injection-Production Pressure System in Medium Water-Cut Period of Shanshan Oilfield
鄯善油田中含水期注采压力系统建立与评价
14.
Development of Multi-Channel Data Acquisition System Based on LabVIEW for Plastic Injection Moulding Machines
基于LabVIEW的多通道注塑机数据采集系统开发
15.
An (artificial) intelligence system:perform high quality data management and statistical analysis from datacollection to statistical report for liver transplantation
中国肝移植注册人工智能系统——从原始数据采集到统计分析报告
16.
Theoretical Analysis and Experimental Study on Improving the Energy Efficiency of Steam Injection System for Heavy Oil Recovery;
提高稠油开采注汽系统能量利用率的理论分析与试验研究
17.
The Study of Permanent Magnet Synchronous Motors Control System That Checks Position Using High Frequency Voltage Signal Injection;
采用高频电压信号注入法检测位置的PMSM控制系统研究
18.
Study on Effect of Chemicals for ASP Flooding on Scaling and Corrosion in Injection-Produced System
复合驱化学剂对注入—采出系统结垢、腐蚀影响的研究