1.
Application of Valve-gate Technology in the Control of Weld Lines of Large Injection Molded Products
阀式浇注技术在控制大型注塑件熔接痕中的应用
2.
Analysis and Control of Weld Marks of Auto Lamp Reflector Based on Valve-injection
基于阀式浇注系统的车灯反射体熔接痕的分析与控制
3.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
4.
The Environmental Aspects Analysis For Epoxy Cast Resin Dry-type Transformers
环氧树脂浇注干式变压器环保特性分析
5.
The new type insulation cylinder used in cast resin transformers
新型结构绝缘筒在浇注型干式变压器中的应用
6.
Application Study of Gussasphalt Concrete on Pavement of Long Span Steel Deck
大跨径钢桥面浇注式沥青混凝土铺装应用研究
7.
Methods and Research on Deterioration of Steel Deck Gussasphalt Concrete Pavement;
钢桥面浇注式沥青混凝土铺装病害分析及对策
8.
Application Technique for Long Span Steel Deck Gussasphalt Concrete Pavement;
大跨径钢桥面浇注式沥青混凝土铺装技术研究
9.
Analysis for thermal ageing problem of resin cast dry-type transformers
树脂浇注干式变压器热老化问题的分析
10.
Closed Integration System for Melting and Pouring Magnesium Alloy
封闭式镁合金熔炼及浇注集成系统的研究
11.
The influence of the filler-asphalt ratio on the high-and-low-temperature performance of gussasphalt mortar
粉胶比对浇注式沥青胶浆高低温性能的影响
12.
Study of the calculating formulas in the minimum section of the gray casting iron pouring system
灰铸铁件浇注系统最小截面积计算公式研究
13.
Design of Pb-Ca Alloy Automatic Casting System Based on The S7-300PLC
直线往复式铅钙合金自动浇注系统设计
14.
For DN1200～2400 electrie big-bore valve, please specify mounting requirement.
电动大口径阀门应注明是立式还是卧式安装。
15.
The molten metal may enter the ingot mould in two ways: from the top and from the bottom. Top pouring is the simplest and cheapest method, but gives poor control over the rate of pouring.
钢液注入钢锭模可采用两种方式:上注和下注。上注法最简单，成本最低，但不好控制浇注速度。
16.
A new casting technology for inlet manifold in tilt casting machine for gravity die casting was described.
介绍了在可倾式金属型浇注机上制造进气歧管的铸造新工艺。
17.
Study of Monolithic Pouring Derivative PDMS Chip-based Electrophoresis Microsystem and Its Application;
衍生式整体浇注PDMS芯片电泳微系统及其应用研究
18.
The Application Research of Native Hard Bitumen in Gussasphalt;
国产硬质沥青在浇注式沥青混凝土中的应用研究