1.
Pour a solid foundation of cement
浇注坚实的水泥地基
2.
concreting boom
浇注混凝土起重机臂
3.
connecting rod babbitting jig
连杆巴氏合金浇注器
4.
connecting rod bearing pouring
连杆轴承巴氏合金浇注
5.
A mold for the setting of concrete.
模板浇注混凝土的模板
6.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
7.
Technology of Inclined Cast Avoid Appeared the Defects of Misrun in Oven Door Casting
倾斜浇注防止焦炉炉门铸件产生浇不足缺陷
8.
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发
9.
Design of Injection Mold Gating System of the Plastic Gear Based on MoldFlow Software
基于MoldFlow塑料齿轮注射模浇注系统设计
10.
The Design and CAE Analysis in Multy-carities Injection Moding Feed System
多型腔注塑模浇注系统设计及CAE分析
11.
"After each 10 m long Base part-section is concreted, the TVM 18 is relocated, after each roadway surface concreting cycle, the pipe Bridge is moved."
"每浇注10米基底,就移动TVM18, 浇注完一块路面板后,移动管道桥。"
12.
Adeline steelmaking process
阿德莱熔模铝热离心浇注法
13.
"In autumn, 3 m of rough concrete work was completed in the east tube per week."
秋季在东孔每周完成浇注混凝土3米。
14.
starch dropped goods
用淀粉模型浇注成形的糖果
15.
It's mainly used in ladle backing layer and tundish backing layer.
自流浇注料还可采用机械化施工。
16.
The concrete pump is only relocated after a number of sections have been completed.
浇注完数段路面板后,才移动混凝土泵。
17.
Technical specification for integralpouring antistatic terrazzo floor
整体浇注防静电水磨石地坪技术规程
18.
The a mixture of lime,clay,and sand to which water is winding to suffer that the pulling reinforing steel gives the pouring.
三合土是绕着受拉钢筋予以浇注的。