说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 纺丝速度
1.
Spinning can be carried out at very high speed and there is very little handling of the thread.
纺丝速度较高且对纱线的接触和操作较少。
2.
THE TECHNICAL INNOVATION ON THE SPINNERET PACK OF NOY HIGH SPEED SPINNING MACHINE.
NOY高速纺丝机纺丝组件的技术改造
3.
These practices shown that the phase-lockd loop has made it possible to offer a stabilized frequency source for high speed spinning of the POY Dacron filament.
实践表明,它解决了涤纶长丝高速纺丝变频电源的频率稳定度问题。
4.
Test spinning of PP microfilaments was carried out in the range of take-up speed from 2000 to 3200 m/ min.
在2000~3200米/分纺速范围试纺微细旦丙纶长丝。
5.
testing method for colour fastness to mercerizing
纺织品耐丝光色牢度试验法
6.
Study on the chip and high-speed spinningfor superfine polypropylene fibers
超细丙纶专用切片和高速纺丝工艺研究
7.
The High Speed Spinning Hollow Fiber Technological Design and the Structure Performance Studies;
高速纺中空长丝的工艺设计和结构性能研究
8.
The Study on Control Technique for Spindle-driven Winders of High-Speed Spinning;
锭轴传动式高速纺丝卷绕机控制技术的研究
9.
Speed Control Switch Mounting Screws
速度控制开关固定螺丝
10.
This dry- spinning process is simpler and quicker than the wet- spinning process used with viscose or cuprammonium rayon.
与粘胶人造丝或铜铵人造丝生产时使用的湿法工艺相比,上述干纺工艺比较简单,生产速度也较快;
11.
Textiles--Tests for colour fastness--Colour fastness to mercerizing
GB/T7073-1997纺织品色牢度试验耐丝光色牢度
12.
Textiles--Tests for colour fastness--Specification for standard adjacent fabric: Silk
GB7568-1987纺织品色牢度试验丝标准贴衬织物规格
13.
Solution spinning process for highly porous,nanostructured cellulose fibers
高度多孔纳米结构纤维素纤维的溶液纺丝工艺
14.
Design and Development of Temperature Control System of High-frequency Heater in the Silk-spinning Machine
纺丝机高频加热器温度控制系统的设计与开发
15.
A small flywheel that regulates the speed of a spinning wheel.
锭盘调整手纺车速度的小飞轮
16.
Purification and Wet-spinning of Recombinant Spider Silk Protein Produced by High Cell Density Fermentation;
蛛丝蛋白工程菌高密度发酵、表达产物纯化与湿法纺丝
17.
garnett wires for worsted spinning
精纺毛纱用garnett丝
18.
The size of the filament is also controlled by varying the rate at which the filaments are pulled away from the hole by the godet wheel.
长丝的直径还与导丝盘从喷丝头孔引离长丝时的速度有关。