说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 盲孔法
1.
Application of Blind Hole Method and Impact Indentation Method in Residual Stress Measurement of Runner of Xiaowan Hydropower Station
盲孔法及压痕法在小湾水电站中的应用
2.
Research on Measuring Welding Residual Stress of Plate of Moderate Thickness Using Blind-hole Method;
中厚板焊接残余应力测试的盲孔法研究
3.
Analysis and experimental study on identification of inner force of steel tube under tension(compression) and bending using blind-hole method
盲孔法识别拉(压)弯钢管内力的分析与试验
4.
Experimental Study and Analysis of Stress Measurement of Circular Steel Tubes by Using Blind-Hole Method
盲孔法测量圆钢管表面应力的试验与分析
5.
Examination and Study on non-penetrating Hole Method Used for Stress in Steel Structure
盲孔法检测钢结构构件应力的试验研究
6.
Numerical Simulation Research of Blind Hole Method Testing Stress of Steel Structure Member
盲孔法检测钢结构构件应力的数值模拟研究
7.
Sticking Technology of Resistance Strain Gauge in Determining Test of Residual Stress by the Blind-hole Technique
盲孔法残余应力测试中的电阻应变片粘贴技术
8.
Research of Numerical Calculating Method for Elastic Release Coefficients in Blind Hole;
盲孔法中弹性阶段释放系数的数值计算方法研究
9.
Application of Improved Blind Hole Method to Welded Iron Tower Joint for Stress Relieving with Heat Aging
改进型盲孔法在铁塔焊接接头热时效消除应力中的应用
10.
Black of the card
盲孔(纹板上无孔的部分)
11.
This paper briefly intro-duced the practice of longhole blast shaft-formirg method for blind shaft sinking in Tongshan Copper Mine.
本文简要介绍了深孔爆破成井法在铜山铜矿盲竖井掘进中的实践。
12.
Micro-via Filling and Through Hole Plating in one Process in Vertical Line
垂直电镀线盲孔和通孔同步电镀工艺
13.
Study on the Physical and Mechanical Performance of Back Covered Porous Brick and Its Masonry;
盲孔多孔砖及其砌体物理力学性能的试验研究
14.
Blind-hole lower bushing prevents leakage.
"盲孔"下部衬垫能够防止泄漏。
15.
Finishing Technology of Large Diameter Blind Holes in Hydraulic Oil Tank Case
液压油箱壳体大盲孔的光整加工技术
16.
Replace length cut springs to std. springs. Close blind holes.
将定尺弹簧改成标准弹簧.关闭盲孔.
17.
FEM simulation of blind bolt connection based on ANSYS
基于ANSYS的盲孔螺栓联接的有限元仿真
18.
An experimental study of drilling small and deep blind holes with an abrasive water jet
磨料水射流钻削深小盲孔的试验研究