说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 临界点蚀温度
1.
COMPARISON OF CRITICAL PITTING TEMPERATURES FOR OIL INDUSTRY STEELS USING ELECTROCHEMICAL NOISE
电化学噪声方法比较石油用钢的临界点蚀温度
2.
a critical temperature of water is 100 degrees C--its boiling point at standard atmospheric pressure; critical mass; go critical.
水的临界温度是摄氏100度——标准大气压下的沸点;临界物质;达到临界。
3.
The critical point,or critical temperature,is the point at which the steel has the most desirable characteristics.
临界点或者临界温度是指钢达到其最合适性能时的点。
4.
upper critical temperature
临界温度上限 临界温度上限
5.
The lower limit of temperature at which this occurs is known as the softening point or critical temperature.
呈现这一性质的温度下限称为软化点或临界温度。
6.
critical temperature thermistor
临界温度热敏电阻器
7.
fine-wire stagnation temperature probe
细丝临界温度探测器
8.
critical temperature of plasma
等离子体的临界温度
9.
In this paper is presented a water vapor pressure cquation with a temper- ature range from three-phase point up to a critical point.
本文提出了一个温度范围从三相点到临界点的水的蒸气压方程。
10.
Experimental Research on Chloride Threshold Level for Reinforcement Corrosion;
钢筋腐蚀临界氯离子浓度的试验研究
11.
CAUSE ANALYSIS OF HIGH TEMPERATURE CORROSION ON WATER WALL OF SUPERCRITICAL ONCE-THROUGH BOILERS AND COUNTERMEASURES THEREOF
超临界锅炉水冷壁高温腐蚀分析及对策
12.
High Temperature Corrosion of Water Cooling Wall of Extrasupercritical Units
超超临界机组水冷壁高温腐蚀问题的探讨
13.
Analysis of the control strategy of the middle point temperature of two types of ultra super-critical 1000MW DC boiler and the effect
两类超超临界1000MW直流锅炉中间点温度控制策略和效果分析
14.
The ceitical valueis stimulus intensity corresponding to the critical point.
临界点所对应的刺激强度为临界值。
15.
The pitting critical potential of the fresh surface is lower than that of the surface covered by passive film.
去膜表面发生点蚀的临界电位低于膜覆盖表面发生点蚀的临界电位。
16.
Characteristics of Metal Corrosion and Deposit Law for Supercritical Units
超临界火电机组的金属腐蚀特点和沉积规律
17.
Study on acid dew point temperature change follow heat pipe tube bank combination
热管管排组合对露点腐蚀温度影响研究
18.
Materials Selection and Preventing Solid Particle Erosion Measures of Ultra-supercritical Steam Turbine's High Temperature Parts
超超临界汽轮机高温部件材料选择与防止固粒侵蚀措施