1.
The Analysis of Fracture for the Flat Head of Universed Joint
1150初轧机万向接轴扁头断裂分析
2.
The Basic Research of Laser Cladding Technology for the Universal Joint Fork's Repair;
万向接轴叉头激光堆焊修复技术的基础研究
3.
Research the Bearing Capacity of Universal-joint Spindle in 170 Piercing Mill Main Transmission System
170穿孔机主传动系统万向接轴承载能力分析
4.
Modification for Spindle Support of Temper Mill;
对平整机万向接轴托架的改造—由固定式改为浮动式
5.
Contact problems for needle bearing of cardan shaft in high speed EMUs
高速动车组万向轴滚针轴承接触问题研究
6.
The two-section propeller is supported by a center bearing and coupled together by universal joints.
两段传动轴之间有一个中间支承轴承,并由万向节连接。
7.
Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke.
将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。
8.
two -joint inboard slip drive shaft
两万向节滑动的传动轴
9.
flange crossing-transmission shaft universal joint
凸缘叉-传动轴万向节
10.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
11.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
12.
Hook's coupling
胡克接头，万向接头
13.
plunging constant velocity joint
可轴向移动的球笼式万向节
14.
An Analysis on Driving System for High Speed Motor Car Bogies with Cardan Shaft
万向轴式动力车转向架驱动系统分析
15.
"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."
万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。
16.
external pressure single type axial expansion joint
外压单式轴向伸缩接头
17.
Four point contract center-oriented thrust Ball bearing
四点接触向心推力轴承
18.
radial bearing upper drive sub
上部径向轴承传动接头