1.
Optimization of Injection Mould and Rapid Setting of Processing Parameters of Injection Moluding Based on Numerical Simulation
基于数值模拟的注塑模具优化及注塑成型工艺参数快速设置
2.
Experiment Research on Influence of Processing Parameters on Part Quality in Injection Molding;
注塑成型工艺参数对制品质量影响的实验研究
3.
The Research of Injection Molding Processing Optimization Based on Hybrid Intelligent Technology;
基于混合智能技术的注塑成型工艺优化的研究
4.
Simulation Analysis and Experiment Research of Process in Micro Injection Molding;
微注塑成型工艺的模拟分析与试验研究
5.
Study on Gas Penetration during Gas-Assisted Injection Molding;
气体辅助注塑成型工艺中气体穿透的研究
6.
Studies on Improving Weld Lines in Molded Parts by Exploiting Sequential Injection Molding
热流道顺序注塑成型工艺改善制品熔接痕研究
7.
Research on Key Technologies of Microcellular Foam Injection Moulding Process
微细发泡注塑成型工艺的关键技术研究
8.
Research on Rapid Heat Cycling Molding and Surface Quality Control of the Parts
高光注塑成型工艺及制品表观质量控制研究
9.
Experimental Optimization of Injection Molding Process and Its Application
注塑成型工艺试验优化方法及应用研究
10.
Research on the Effect of Process Parameters of Microcellular Foam Injection Moulding on Cell Configuration
微细发泡注塑成型工艺对泡核形态影响的研究
11.
Injection Molding Process and Properties of Recycled PP Toughened by POE
POE增韧改性回收PP的注塑成型工艺及其性能
12.
Injection Molding of NdFeB Bonded Magnet from Granulation-free Powder
粉料免造粒粘结钕铁硼磁体注塑成型工艺
13.
Research on the optimization of injection molding process parameters based on sensitivity analysis
基于敏感性分析的注塑成型工艺参数优化
14.
The Molding Technological Research of Large-scale Vehicle Plastic Parts
大型汽车用塑件的注射成型工艺研究
15.
Optimization of the Gas-Assisted Injection Molding Process for the Typical Automotive Plastic Parts
典型汽车注塑件的气辅注射成型工艺优化研究
16.
The Research of Precision Injection Molding of Optical Plastic Lens;
塑料非球面光学镜片注塑成型的工艺研究
17.
Simulation of Injection Molding and Optimization of Molding Parameter for the Plastic Part with Complicated Structure
复杂塑件的注塑成型模拟及工艺参数优化
18.
Process Parameters Optimum of Injection Molding and Injection Mould Design of Plastic Gear
塑料齿轮成型工艺参数优化及注塑模具设计