1.
Research About Compensating Method To Installation s And Manufacture s Error of Pole Track Satellite Antenna;
极轨卫星跟踪天线安装制造误差补偿方法
2.
The Study of the Influence of Manufacturing Error and Trench Structure to Static Rigidity for LMG
LMG制造误差和沟槽结构对静刚度影响的研究
3.
Aerodynamic optimization under operation variations and manufacture errors
考虑飞行条件变化和制造误差的气动优化方法
4.
Error Analysis and Fixture Design in Manufacturing High-precision and Thin-walled Face-gear
高精度薄壁面齿轮制造误差分析及夹具设计
5.
Fabrication deflection of jacket pipe in deep water and its stiffness against buckling
深水导管架桩腿制造误差与抗屈曲特性研究
6.
We can use this method to calculate the mean values and standard deviations of the responses, and estimate the stochastic errors of structural characters resulting from the fabrication errors.
利用此法，能计算结构静响应的均值和标准差，估价制造误差引起的结构力学性能的随机性误差。
7.
The Distributed Test and Analyzing System for the Planar Enveloping Hourglass Worm Gearing;
平面包络环面蜗杆制造误差的分布式检测分析系统
8.
Research progress of hydrodynamic journal bearing system dynamics allowing for manufacturing tolerances
考虑制造误差时滑动轴承转子系统动力学研究进展
9.
Study on Meshing Analysis and Meshing Control of Double-enveloping Hourglass Worm-gearing Affected by Misalignment Errors and Load-dependent Deformation
制造误差与承载变形耦合条件下平面二次包络环面蜗杆的啮合分析与啮合控制研究
10.
Application of Error Compensation Technology to Sustainable Manufacture
误差补偿技术在可持续制造中的应用
11.
Computer Aided Error Diagnosis on Multi-stage Manufacturing Process;
多工序制造过程计算机辅助误差诊断控制系统
12.
There exist manufacture and install errors in the actual six degrees of freedom motion platform, these errors will affect the platform's position and pose precision.
实际的六自由度转台存在着制造、装等误差,这些误差都会影响转台的位姿精度。
13.
Research on Vortex Torque of the Three-Axis Air Bearing Testbed Caused by Manufacture Errors and Fix-Errors of Ball Bearing;
三轴气浮台球轴承制造及安装误差引起的涡流力矩的研究
14.
Research on Recognition and Assessment of Typical Planar Curves Used in Precision Manufacturing
精密制造中典型平面曲线的识别及形状误差评定研究
15.
Study on Dephasing Calibration of Periodical Error and Core-tip Positioning System in Making Precision Rotary Cutting Tools
回转类精密刀具制造用芯轴定位系统及周期误差移相修正研究
16.
Error Adaptive Control Computer
误差自适控制计算机
17.
The omisson in function transformer only brings about voltage error but not test error.
函数变压器中的省略只会造成电压误差,不会造成测量误差。
18.
The error we committed is only 0. 5 min.
我们造成的误差只有0．5分钟。