1.
Study on Titration of Citric Acid by Potassium Permanganate with Open Circuit Potential Method
开路电位法研究高锰酸钾滴定柠檬酸
2.
Analysis and Solution for Current Overload and Potential Reversion Happened in Cathodic Protection System
阴极保护系统输出电流和开路电位异常的故障分析
3.
REPAIR THE OPEN CRANK POSITION SENSOR SIGNAL CIRCUIT.
维修断开的曲柄位置感知器信号电路。＊
4.
The Interface Circuit of 960 Bit Switching Quantity Signal Detecting System
960位开关量信号检测系统接口电路
5.
Represents a spring return (break). Right-click to open and close the circuit.
表示弹簧复位（断开）。右击断开或接通电路。
6.
Represents a spring return (break). Circuit can be specified as open or closed.
表示弹簧复位（断开）。可指定电路为断开或接通。
7.
The Research of Clamp Circuits in 50W Flyback Switching Power Supply with High Power Factor
50W高功率因数反激式开关电源箝位电路的研究
8.
Research on Open Circuit Voltage of Solar Cell Under the Modulation of Lens Focus Position
透镜焦点位置调制太阳电池开路电压的研究
9.
REPAIR THE OPEN OIL PRESSURE SWITCH SENSE CKT BETWEEN THE SWITCH AND THE INSTRUMENT CLUSTER.
修理位于开关和仪表组之间油压开关感知电路断路。
10.
T3Manual Valve Lever Position Switch C3 Sense or Park/Neutral Position Switch Sense circuit.
＊＊Ｔ３＝手工阀门操纵杆位置开关Ｃ３感知或停车／空档位置开关感知电路
11.
Represents a spring return (make). Circuit can be specified as open or closed.
表示弹簧复位（闭合）。可指定电路为断开或接通。
12.
Represents a spring return (make). Right-click to open and close the circuit.
表示弹簧复位（闭合）。右击断开或接通电路。
13.
Design and Development of Traveling-wave Fault Location System of High Volt Power Lines;
高压输电线路行波定位系统的设计与开发
14.
Trigger circuit, power supply circuit, clocking circuit and reset circuit are the main circuits on the main board.
触发电路、供电电路、时钟电路、复位电路是主板上最主要的电路。
15.
symmetrical heterostatic circuit
对称异电位差连接电路
16.
black level clamping circuit "
黑色"电平箝位电路
17.
plitude-controlled clamp
电压振幅箝位控制电路
18.
multiplexer switch circuit
多路转换器开关电路