1.
Study on Minimum Spouting Velocity in Liquid and Solid Bed with Draft Tube
带导流管液固喷动床的最小喷动速度研究
2.
Study for the Minimum Spouting Velocity and Pressure Fluctuation Characters of an Annual Spouted Bed Using Fine Particles
细颗粒环形喷动床的最小喷动速度和压力波动特性研究
3.
and the minimal spouted Reynold was greatly affected by the ratio of densities when static bed height located in the spouted cells.
静床层高度位于锥形喷动室内时,密度之比对最小喷动时的雷诺数的影响较大;
4.
Passing through the nozzle at the highest speed, Impulse turbine steam directs against a row of blades which assembled in the axles of Impulse turbine with radiation shape.
当蒸汽以最高速度从喷嘴里喷出时，便冲击一列呈辐射状安装在涡轮机主轴上的动叶片。
5.
RIGID PLASTIC DYNAMIC PROBLEM BASED ON THE MINIMUM ACCELERATION PRINCIPLE
基于最小加速度原理的刚塑性动力问题
6.
Testing Study of Effect of Burden on Motion Speed of Interlayer Fill Soil
最小抵抗线对层间充填土运动速度影响的实验
7.
Dynamic Modeling of Acceleration Sensor Based on Generalized Least Square Method
基于广义最小二乘法加速度传感器的动态建模
8.
Such high-speed jet aircraft have a speed of 700m.p.h.
这样高速喷气式飞机的速度为700英里/小时。
9.
minimum adjustable table speed
工作台最小调整速度
10.
Estimation Method of Nozzle Exit Speed for Torpedo Turbine Engine
涡轮发动机喷管出口速度的估计方法
11.
dead-slow speed servomotor
最小转速伺服电动机
12.
The emphasis on the minimum nozzle length was carried to the limit with the design of nozzle with sharpedged throats.
强调最小喷管长度转向采用锐边喉管道的喷管设计的极限值。
13.
Study on Idle Speed Control Strategy for Low-displacement EFI Engine;
小排量电喷发动机怠速工况控制方法研究
14.
a simple type of jet engine; must be launched at high speed.
一种简单的喷气发动机；必须以高速度发射。
15.
Another one is based on a design meth-od of the minimum length nozzle.
另一种是基于最小长度喷管的设计方法。
16.
ELASTIC-PLASTIC DYNAMIC RESPONSE ANALYSIS OF SANDWICH BEAMS WITH LATTICE TRUSS CORES BASED ON MINIMUM PRINCIPLE OF ACCELERATION
基于最小加速度原理分析点阵材料夹芯梁的弹塑性动力响应
17.
synergic ascent
最优上升(以最佳速度、最小燃料消耗量上升)
18.
outlet triangle
喷嘴出口速度三角图