1.
Surface defect terms
GB/T15757-1995表面缺陷术语
2.
Inspect for cosmetic acceptability per cosmetic defect inspection procedure.
依照表面缺陷检验程序做表面检验
3.
Ingot defects may be broadly classified into internal flaws and surface flaws. Internal flaws are caused by shrinkage.
钢锭缺陷广义上可分为内部缺陷和表面缺陷。内部缺陷是因收缩引起的。
4.
Surface discontinuities of fasteners on nuts for general requirements
GB/T5779.2-1986紧固件表面缺陷--螺母--一般要求
5.
Research on the Methods of Recognition Based on Disfigurement of Zonal Steel Surface;
带钢表面缺陷智能化辨识方法的研究
6.
Design and Research of Recognition System on Railway Surface Defects;
钢轨表面缺陷识别系统的设计与研究
7.
Research on Control System of Inspecting Instrument for Steel Ball Surface Defect
钢球表面缺陷检测仪控制系统的研究
8.
The Analysis for the Surface Defect of the SAE10B08 Pickled Hot-rolled Wire Rod
SAE10B08钢酸洗线材表面缺陷分析
9.
Coating surface defect on hot-dip galvanized steel sheet and its preventive measures
热镀锌板镀层表面缺陷及其消除措施
10.
CONTROL OF SURFACE DEFECTS IN HgCdTe FILM GROWN BY LIQUID PHASE EPITAXY
HgCdTe液相外延薄膜表面缺陷的控制
11.
Determination of Surface Defects of Green Orange Based on Computer Vision
绿橙表面缺陷的计算机视觉分级技术
12.
Defect Detection of Empty Bottle Surface Based on Machine-Vision
基于机器视觉的玻璃瓶表面缺陷检测
13.
Subsurface Damage Structure and Eliminating
减少光学元件亚表面缺陷的方法研究
14.
Analysis of surface defect on H68 copper alloy strip
H68铜合金带材表面缺陷成因分析
15.
unclean surface
不洁的[有缺陷的]表面
16.
Research for Relationship between Steel Defects and Slabs Defects
带钢表面翘皮缺陷与板坯缺陷对应性关系研究
17.
Slip- A defect pattern of small ridges found on the surface of the wafer.
划伤-晶圆片表面上的小皱造成的缺陷。
18.
Mound- A raised defect on the surface of a wafer measuring more than0.25 mm.
堆垛-晶圆片表面超过0.25毫米的缺陷。