1.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
2.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
3.
Measurement of Dynamic Stresses and Temperatures of Main Bearing Walls and Caps on an Engine Block
发动机缸体主轴承座及主轴承盖的动态应力和温度测量
4.
Influence of the Pouring System and Die Casting Technology on the Quality of Bearring Cap
浇注系统及压铸工艺对轴承盖质量的影响
5.
3D Finite Element Analysis of Suspended Main Bearing Cap of Diesel Engine
柴油机悬挂式主轴承盖的三维有限元分析
6.
3D Finite Element Analysis of Stiffness and strength of Main Bearing Cap of Internal combustion Engine
内燃机主轴承盖强度和刚度的三维有限元分析
7.
The bearing shells must be installed so that the tangs are in the machined grooves in the rods and caps.
安装轴瓦时，应使凸舌位于连杆和轴承盖的加工槽内。
8.
Remove the depth shims from rear pinion bearing cup bore in axle housinRecord the thickness of the depth shims.
从轴管里的后小齿轮轴承盖孔拆卸限深垫片。记录限深垫片厚度。
9.
end shield bearing
机油滤清器内盖头轴承
10.
Analysis and solution of cramped shield to be detachable in sealing bearings
带卷边防尘盖轴承活盖问题解决办法
11.
Place 4 adapter blocks so they do not damage the bearing cag
安装4个接头垫块，以免损坏轴承弹子盘盖。
12.
Manufacturing dustproof cap of bearing and roller in composite mould are introduced.
介绍了用复合模生产轴承及滚轮防尘盖的过程。
13.
Oil may be forced out through the timing cover and rear-main bearing oil seals.
机油会从正时齿轮盖和后主轴承油封处压出。
14.
Permanently sealed and lubricated ball bearings front and rear.
前后端盖装有永久密封和自润滑的滚珠轴承。
15.
Renewal and Transformation of Bearing Sealing Cover on Yantan Hydropower Co. Ltd.
岩滩发电公司机组轴承密封盖更新改造
16.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
17.
Plain Bearing Block Housings are made up of cap, base ,aluminum bronze bushing and installing bolts, which mainly bear radial load.
滑动轴承座由上盖、底座、剖分轴瓦（铝青铜），安装螺栓组成，主要承受径向载荷。
18.
The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.
下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。