1.
Research and Application of CAPP for Cold Extrusion Process
冷挤压工艺设计CAPP系统的研究及应用
2.
Development and Application of CAPP for Cold Extrusion Process
冷挤压工艺设计CAPP系统的开发与应用
3.
Research on Cold Extrusion Process Design System and Its Key Technologies;
冷挤压工艺设计系统及其关键技术研究
4.
Research on applications of fuzzy ANN in cold extrusion process design
模糊人工神经网络在冷挤压工艺设计中的应用研究
5.
Research on Knowledge-Based Intelligent System and Key Technologies of Cold Extrusion Process Planning;
基于知识的冷挤压工艺设计智能系统及其关键技术研究
6.
Cold Extrusion Process and Die Design of Cups with Bosses
圆形凸台件的冷挤压工艺及模具设计
7.
Cold-extrusion process and die design of plane-chair-clasp cylinder
航空座椅锁扣缸体冷挤压工艺及模具设计
8.
Cold Extrusion Process Simulation for Flywheel's Inner Ratchet and the Die Design;
飞壳内棘齿冷挤压工艺模拟分析及模具设计
9.
Cold Extrusion Process for Involute Spline Part and Concave Die Optimize Design Based on Numerical Simulation;
基于数值模拟的渐开线花键件冷挤压工艺及凹模优化设计
10.
Research on Rectangle Spline Cold Extrusion Process and Optimizing Design of Multi-Layer Composite Concave Die;
矩形花键冷挤压工艺研究及组合凹模的优化设计
11.
Research on Cross-Shaft Cold Extrusion Forming Process and Digitization on Mould Design;
十字轴冷挤压成形工艺研究及模具设计数字化系统开发
12.
Inner ratchet's cold extrusion process design and numerical simulation
飞壳内棘齿冷挤压成形工艺设计及数值模拟分析
13.
Design of Extrusion Mode and Extrusion Processing of Wrought Magnesium Alloys with Complex Cross-Section;
镁合金型材挤压模具设计与工艺研究
14.
Composite Extrusion Technics and Mould Design of Alumium Alloy Tie Bar
铝合金拉杆复合挤压工艺及模具设计
15.
Drawing of Cold Stamping Process of Bearing Frame and Die Design
轴承架的冷冲压拉深工艺及模具设计
16.
On teaching mode of cold forming process and mode design
“冷冲压工艺与模具设计”教学模式探讨
17.
Cold punching processing design of the FH_2-40 motor's rear cover
FH_2-40型电动机后端盖冷冲压工艺设计
18.
Study on Extrusion Deformation Laws and Technics for the Covering Element;
罩体冷挤压成型变形规律及工艺研究