1.
Permeability of Cutting Fluid in Minimum Quantity Lubrication Precision Turning
最小量润滑精密车削中切削液的渗透性
2.
Research on the Minimum Quantity Lubrication Cutting Technology Based Effervescent Atomization;
基于气泡雾化小量润滑切削技术研究
3.
If the level is below the maximum mark, top up with the right grade of Shell Helix.
如果油量低于最小刻度，则应选择正确级别的壳牌喜力发动机润滑油给予添加补充。
4.
LOWEST OIL FILM THICKNESS ANALYSIS OF AEAR DRIVE & IMPROVE IUBRICATION MEASURE
齿轮传动最小油膜厚度分析及改善润滑的措施
5.
Lubrication with a watersoluble jelly is preferred.
最好用水性胶润滑剂。
6.
lubricating oil metal test
润滑油金属含量试验
7.
testing method for evaporation loss of lubricating grease
润滑脂蒸发量测定方法
8.
Usage: lubricate cutter before starting work, lubricate it every one hour.
使用方法：工作前润滑刀具，每个小时润滑一次。
9.
Analysis on Measurement Approach for Lubricant Film Thickness of Sliding Bearing
滑动轴承润滑油膜厚度测量方法分析
10.
profit-maximizing capital stock
利润最大化的资本存量
11.
Why has my oil consumption increased since changing to a Shell oil?
为什么在改用了壳牌公司 的润滑油以后，我的润滑油耗油量增加了?
12.
The experimental results indicate that cryogenic nitrogen gas jet with minimal quantities of lubricant is the most effective cooling and lubricating mode to reduce milling force and to retard tool wear.
试验结果表明，低温氮气射流结合微量润滑能够最有效地降低铣削力，抑制刀具磨损。
13.
testing method for ash content of lubricating grease
润滑脂灰分含量测定方法
14.
analysing method for mineral oil content of lubricating grease
润滑脂中矿物油含量测定法
15.
testing method for deleterious particles in lubricating grease
润滑脂中有害微粒物含量测定法
16.
testing method for insolubles in used lubricating oils
废润滑油中不溶解物含量测定法
17.
lubrication oil and additives-determination of sulfated ash
润滑油及添加剂-硫酸灰分含量测定
18.
INFLUENCE OF LUBRICANT DOSAGE ON RIGID PVC PROPERTIES
润滑剂用量对硬质PVC性能的影响