说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 传感器网络寿命
1)  sensor network lifetime
传感器网络寿命
2)  lifetime of wireless sensor networks
传感器网络生命期
3)  sensor lifetime
传感器节点寿命
1.
The simulative results clearly show that the power consumed under OTPSA is greatly less than the maximum power gotten at each node,and can be regulated according to the fluctuation of the requirement of maximum rate and the background noise;sensor lifetime can also be prolonged by implementing the proposed scheme.
仿真结果表明,本算法得出的最优传输功率大大小于传感器节点可获取的最大功率,并可以根据网络背景噪声和最大传输速度的变化而动态调整;该算法可以较为显著地延长传感器节点寿命;另外,仿真结果还表明本算法的实现成本是合理的且可接受的。
4)  network lifetime
网络寿命
1.
For each node in Wireless sensor networks (WSN) has only limited energy, it is important to design a power-efficient routing protocol to extend the network lifetime.
仿真结果表明,相比分布式的WRT算法,该算法能使网络不同比例节点的存活时间提高10%~500%,同时提高网络节点的负载均衡性,从而有效地延长网络寿命。
2.
We present a new best energy route discovery method which could meet the requirements of QoS bandwidth and has better network lifetime.
另外,通过实验仿真与分析,给出了本文遗传算法的控制参数的选择区间,实验显示本文提出的满足QoS带宽需求的路由发现方法对无线传感器网络具有更好的适应性和更长的网络寿命。
3.
Experimental results show that our algorithm has a better performance on network lifetime than the common clustering algorithms.
实验结果表明,新算法较常见分簇算法更能够延长网络寿命。
5)  network life
网络寿命
1.
In Wireless sensor networks, node’s energy is constrained, so the task scheduling algorithm not only to ensure the success rate of tasks dynamic scheduling, but also to extend network life.
因为无线传感器网络的能量受限特点,所以任务调度算法要在保证任务调度成功率基础上,尽量降低任务能耗以延长网络寿命。
2.
The results show that the network life can be improved 5 times than that of fixed node\'s transmitting power only by selecting the optimal transmitting power.
采用更精确的分析方法,给出使得网络总能量消耗最小,网络寿命最长时的缓冲区位置与能量发射级别参数的选取方法。
3.
Based on this,the best energy transmitting power which can make the largest network life is gained,and a policy is put forward to prolong network life and keep a high rate of data collection.
分析圆形无线传感器网络的数据转发特征,得到使网络寿命最大的节点能量发射功率。
6)  sensor network
传感器网络
1.
Realization of hiberarchy wireless sensor network for mine laneway monitoring;
矿井巷道层次型无线监测无线传感器网络的实现
2.
IrisNet:wide-area sensor networks services;
IrisNet:一种广域传感器网络的服务
3.
Dynamic data fusion algorithm based on energy restraining in sensor network;
一种基于能量约束的传感器网络动态数据融合算法
补充资料:变压器式传感器
      利用变压器作用原理把被测位移转换为初、次级线圈互感变化的变磁阻式传感器。它由两个或多个带铁心的线圈构成,初、次级线圈间的互感能随衔铁或两个线圈间的相对移动而改变。当用适当频率的电压激励初级线圈时,次级线圈的输出电压将随互感的改变而变化,从而将被测位移转换为电压输出。这种传感器在使用中常采取两个同名端串接的次级绕组线圈,以差动方式输出,所以又称为差动变压器式传感器。变压器式传感器的特点与电感式传感器相同,有时亦称电感式传感器。但变压器式传感器在设计上具有更大的灵活性,应用更为广泛。旋转变压器、感应同步器、自整角机都属于变压器式传感器。变压器式传感器主要用于测量位移和能转换成位移量的力、张力、压力、压差、加速度、应变、流量、厚度、比重、转矩等参量。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条