1) Ultra-fine crushing by roller press
辊压超细碎
2) crushing roll
压碎辊
3) gear roller crusher
齿辊细碎机
1.
The special technical features of the newly domestic manufactured knockdown gear roller crusher are being delineated,its reliability in matching CFB boilers analyzed,and technical measures taken for meeting the boiler fuel s requirement in granular fineness explained.
阐述了国产新型组合式齿辊细碎机技术特点。
4) ultra-fine grinding
超细粉碎
1.
Progress of ultra-fine grinding and classifying techniques in China;
中国超细粉碎和精细分级技术现状及发展
2.
Through experimental studies on ultra-fine grinding of molybdenite,it can be found that there is the effect of density in grinding,the ratio of ball to ore,ball distribution,rotating speed of mill, the consumption of dispersant,grinding time on grinding process.
对润滑剂级辉钼矿进行超细粉碎研究,研究了磨矿浓度、球矿比、球径配比、搅拌转速、水溶分散剂用量、磨矿时间对超细磨矿结果的影响。
3.
The present states of the ultra-fine grinding technology and equipment for non-metallic ores are reviewed in recent years in China.
综述了我国近年来非金属矿超细粉碎技术和设备的发展现状 ,指出了制约国内技术和设备发展的几个问题 ,结合超细粉体粒子微细化、表面活性化、用途功能化、组成高纯化、产品系列化的性能要求 ,提出了我国超细粉碎技术今后的发展方向。
5) ultrafine grinding
超细粉碎
1.
Influence of liquid medium on ultrafine grinding of pyrite;
液体介质对黄铁矿超细粉碎的影响
2.
Study of ultrafine grinding of pyrite catalyst used in direct coal liquefaction;
煤直接液化用黄铁矿催化剂超细粉碎的研究
3.
Affecting mechanism of grinding aid during ultrafine grinding;
超细粉碎过程助磨剂的作用机理
6) superfine crushing
超细碎
1.
Study of superfine crushing scheme in Dading Iron Ore Mine;
大顶铁矿超细碎工艺方案的探讨
补充资料：细碎
细碎
fine crushing
X ISUI细碎(fine erushing)破碎工艺流程中继中碎之后的第三段破碎。中碎的产物即为细碎的给料，给料杜度为19(40)一100(150)mm，产物粒度为4.8(5)一25(30)mm。细碎多使用短头型圆锥破碎机、反击式破碎机或锤式破碎机;小型选矿厂亦可采用双腔回转破碎机或棍式破碎机。产物粒度多为10mm左右，通常为12~15mm。细碎设置于选矿厂的破碎车间内，通常与筛分构成闭路，以严格控制产品粒度。 (徐秉权)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条