2) swing link cam
摆杆凸轮
1.
The theoretical contour curve equation and the actual contour curve equation of two sides of swing link cam are deduced in the pole coordinate system respectively, and the equation based on two different pole coordinate system are consolidated into one in succession.
研究了摆杆凸轮左右两部分理论轮廓曲线方程和实际轮廓曲线方程,并把两组极坐标系中的方程统一于一组极坐标系中。
3) mechanism of disk cam with an oscillating follower
摆杆盘形凸轮机构
4) Cycloid cam
摆线凸轮
1.
In this paper,models of the cycloid cam mechanism are established.
对摆线凸轮-从动杆机构,提出线性及非线性模型,并应用拉氏变换分析了该系统的动力学问题,为进行现代化设计提供了理论依据。
5) rocking cam
摇摆凸轮
6) swing cam
摆动凸轮
1.
By means of chemical composition analysis,hardness testing,fracture analysis and so on,the reason of the fracture of 40Cr swing cam which was applied to load-carrying vehicle was analysed.
采用化学成分分析、硬度测试和断口分析等方法分析了某载重车辆钢摆动凸轮断裂的原因。
补充资料：凸轮
1.一种具有曲面周缘或凹槽的零件。种类很多，可以推动从动零件作往复移动或摆动。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条