1) build-up intensity
导向强度
1.
The paper discussed and analyzed an important parameter—build-up intensity(the drift angle\'s change of drilling hole in one meter length drilling,degree/meter) which influences the hole section designed.
初步探讨、分析了影响钻孔轨迹设计的重要参数——导向强度(单位钻进长度钻孔顶角的变化量,°/m)。
2) Forced-directed oil cooling
强油导向
3) forced guiding
强迫导向
1.
This article mainly describes the technology development of mechanical vibrator from forced guiding to nonforced guiding by means of nonforced guiding technology on mechanical vibrator and the basic principle of performing vertical and horizontal vibrations on the same table.
简要论述在机械振动台上如何应用无强迫导向技术,实现机械振动台由强迫导向到无强迫导向的技术发展,在同一工作台面上实现垂直振动和水平振动的基本原理。
5) radial strength
径向强度
1.
Multiring pressfit is one effective way of solving the problem that the radial strength of composite flywheel is too low.
采用多环过盈装配是解决复合材料飞轮径向强度过低的有效途径之一。
6) axial strength
轴向强度
1.
The result presents that if the GFRP layer is 2 21mm thick,the axial strength of the C30 concret.
计算结果表明 ,2 2 1mm厚的GFRP补强层 ,可使直径 40 0mm的C30混凝土圆柱 ,轴向强度由 30MPa提高到 5 0MPa、失效应变提高 18 5倍。
补充资料：导向
引导的方向：新闻工作要坚持正确的舆论导向。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条