说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 重塑粉土
1)  remolded silt
重塑粉土
1.
Through the direct shear experiments under the conditions of different initial moisture contents,different dry densities and different vertical pressures,this paper researches the regularities of the change of the strength index of remolded silt affected by these external factors.
通过在不同初始含水率、不同干密度、不同垂直压力条件下的直剪试验,研究重塑粉土强度指标随这些外部因素的变化规律,研究表明,垂直压力、干密度的增大对提高重塑粉土峰值强度作用明显,随初始含水率增加,重塑粉土土体峰值强度的剪切位移增加,而峰值强度、黏聚力、内摩擦角都有先增大后减小的趋势。
2)  remolding powdered soil of coal measure strata
重塑粉状煤系土
3)  remolded soil
重塑土
1.
As undisturbed soil and remolded soil possess different structural features, they demonstrate different mechanical properties.
原状土与重塑土具有不同的结构特征,于是表现出不同的力学性状。
2.
With the comparative analysis of triaxial tests of undisturbed and remolded soil samples, the influences of structure on the stress-strain shear moduli of soil samples at the initial, medium and later stages of the test have been discussed, and from the microscopic angle, its causes are analyzed qualitatively.
通过原状土样和重塑土样的三轴试验的对比分析 ,结构性对土样的应力应变切线模量在试验的初期、中期和后期的影响进行了探讨 ,从微观角度定性地分析其原因。
3.
In laboratory,remolded soils are subjected to acid water immersion and tested for changes in their mineral compositions and shear strength after immersion with different durations.
在实验室内用弱酸溶液浸泡蒙脱石、伊利石、高岭石3种重塑土试件,测试不同浸泡时间后试件矿物成分和抗剪强度的变化,以此模拟现场酸雨作用下滑面的形成过程。
4)  remolded soils
重塑土
1.
Analysis of the experimental parameter of remolded soils physical and mechanical properties;
重塑土物理力学特性试验参数的影响因素分析
2.
Shear strengths of undisturbed and remolded soils of typical vegetations in Jinyun Mountain of Chongqing City;
重庆缙云山典型植被原状土与重塑土抗剪强度研究
5)  remolded clay
重塑黏土
1.
Based on the viewpoint of interaction between volumetric and shear strains in plastic deformation for rock and soilt,he elastoplastic constitutive model for remolded clay under reduced triaxial compression(RTC) path has been established by using the numerical modeling method,which provides a practicable constitutive equation for computer simulation of excavation works.
根据岩土塑性变形中体应变与剪应变之间相互作用的观点,采用数值建模方法建立减围压三轴压缩应力路径下重塑黏土的弹塑性本构模型,为土体挖方工程的计算机仿真提供符合实际的本构方程。
6)  reborn sample
重塑土样
1.
Relationships between moisture content,displacement and height of reborn samples are established based on test results.
通过控制土样的含水量和土性指标,获得与原状土性质相仿的重塑土样。
补充资料:土塑
1.泥塑。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条