1) ratio of injection flux
注气流量比
2) gas flow
注气流量
1.
On the basis of experiments,the factors which influenced the shape of PA12 double-lumen catheter cross-section in process of extrusion,including the die temperature,the screw rotational speed,the tractive rate and the volumetric gas flow were analyzed.
在实验的基础上,分析了聚酰胺(PA)12双腔医用导管挤出过程中机头温度、螺杆转速、牵引速率和注气流量对导管截面形状精度的影响。
2.
In this dissertation, gas flow controller system was designed.
为得到较好的导管截面形状,本文从材料的流变特性、机头设计、注气流量的控制以及挤出工艺参数的调节四个方面进行了实验研究,得出的结论对双腔导管的挤出成型有一定的参考作用。
3) ratio of gas flowrate
气体流量比
1.
Effect of ratio of gas flowrate on Si_3N_4 thin films prepared by reactive magnetron sputtering;
气体流量比对反应溅射Si_3N_4薄膜的影响
4) Ar/N2 flow rate
氩气/氮气流量比
5) water/air mass flux ratio
液气质量流量比
1.
Droplet size of two-fluid airblast atomizer with lar ge water/air mass flux ratio;
大液气质量流量比双通道气流式喷嘴雾化滴径
6) air/liquid mass flow rate
气液质量流量比
1.
The velocity profiles of spray are similar at all experimental conditions,but the cone angle becomes slightly smaller under high liquid mass flow rate and low air/liquid mass flow rate(RAL).
利用Dual PDA对气泡雾化喷嘴出口下游的喷雾两相流场进行了诊断与分析,发现气液质量流量比对液雾颗粒群速度分布的影响不大,只是轻微地改变了雾化锥角,但是随着气液质量流量比的减小,雾化颗粒平均直径却有所增大。
补充资料：中毒量
中毒量
toxic dose
超过极量能引起中毒的剂量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条