1) thickness ratio
厚度配比
1.
The influence of thickness ratios on the fatigue behaviors of two kinds of dental ceramic
厚度配比对2种牙科陶瓷疲劳行为的影响研究
2) The distribution of thickness
厚比分配
3) Thickness Ratio
厚度比
1.
Based on the mechanics of deformation,a series of tailor welded blank with different thickness ratios for expanding process were studied by finite element method.
从材料的变形机理出发,针对厚度比不同的拼焊板,通过有限元分析方法对降低成形极限的原因进行了分析和解释,证实焊缝两侧金属的变形条件差异和变形路径是影响整体变形程度的重要因素。
2.
The thickness ratio of aluminum and copper has a very important effect on the property of Al/Cu clad sheet.
说明神经网络模型很适合拟合轧制工艺参数和双金属板厚度比之间的非线性关系。
3.
We manufactured stainless steel cladding aluminum sheet (SUS304/AA3003)with 1 5mm thick and different thickness ratio,and studied the effect of thickness ratio on the formability of this cladding sheet.
研究了厚度比 ηｓ 对 Ｓ Ｕ Ｓ３０４／ Ａ Ａ３００３ 层压复合板成形性能的影响。
4) rudder thicknessratio
舵厚度比
5) ratio of variable thickness
变厚度比
1.
5 )The variable thickness slab has good technico-economical index, The thick plate should not be too thick,if it want to well-design,the thin plate is also should net be too thin,the ratio of variable thickness should be bigger or equal to 0.
本文采用SlabCAD对变厚度板的内力与变形进行分析,提出了设计计算的具体要求,并得出以下结论:1)变厚度中空板是一种优化的板型,内力分布优于平板,变形特征又与平板相似,因此厚板不同于扁梁,决定了变厚度板的设计计算特点;2)变厚度板的厚板配筋是由裂缝控制等级确定的;3)中空设计不仅能减轻楼板自重,从成空截面分析,还能降低配筋量;4)厚板的高度大,又布置在板的内力较大处,适合于施加预应力,板带之间的预应力效应是相互影响的,文中给出了计算板带预应力的方程组;5)变厚度板具有较好的技术经济指标,要设计好变厚度大板,厚板不要太厚,薄板不能太薄,变厚度比应大于等于0。
补充资料：厚度
扁的物体上下两面之间的距离。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条