2) crude oil electric dehydrator
原油电脱水器
1.
A discussion on crude oil electric dehydrator design including process calculation,internals instruments and electricity were taken out,followed by an analysis based on the discuss to solve possible problems in practical applications and a final discuss of various factors which have affections on crude oil dehydrators.
对原油电脱水器工艺计算、内件设计、仪表设计以及电气设计进行了讨论,并对在实际设计过程中可能出现的问题提出了看法,最后讨论了电脱水器的综合影响因素。
3) crude oil dehydration
原油脱水
1.
With some measures to increase production being adopted, the density and viscosity of the crude oil as well as the polymer content have been increased, leading to increasing difficulty in crude oil dehydration and waste wa- ter treatment.
孤岛油田进入特高含水开发期,注聚、稠油热采等三次采油工艺和其他增产措施应用后,采出液的原油密度和粘度增大、聚合物含量增加,使原油脱水和污水处理难度越来越大。
2.
The reconstruction of crude oil dehydration unit in Shanshan oil field is outlined.
对鄯善油田原油脱水系统实施的工艺技术改造进行了总结。
4) crude dehydration
原油脱水
1.
This increases the equipment working load,consumes much more chemical dehydrite,and increases crude dehydration material cost.
随着油田的开发进入中后期,原油含水量逐渐上升,使联合站进站液量大,增加设备处理负荷,化学药剂消耗量加大,原油脱水能耗加大。
5) dehydration of crude oil
原油脱水
1.
Studies the effects of the magnetic treatment on dehydration of crude oil,wax avoid ance and viscosity reduction,and purification of waste water and avoidance of scale formation.
用多极电磁器试验研究了磁处理在原油脱水、防腊降粘,原油废水的净化及电磁防垢方面的作用。
6) Crude oil dewatering
原油脱水
1.
Study of characteristics of crude oil dewatering process in joint station;
联合站原油脱水过程工艺特性
补充资料：原油脱水
分子式：
CAS号：
性质：原油在井下直接与水接触，井口采出的原油伴有大量的水。一般在油田从原油中脱水，并将脱出的水回注井下的过程称为原油脱水。脱水时往含水原油中加入破乳剂，油水经沉降分离。为确保原油含水量达到指标，在最后的沉降罐内安装高压电极，使油水在电场下分离。外输原油的含水量要求不大于0.5%。
CAS号：
性质：原油在井下直接与水接触，井口采出的原油伴有大量的水。一般在油田从原油中脱水，并将脱出的水回注井下的过程称为原油脱水。脱水时往含水原油中加入破乳剂，油水经沉降分离。为确保原油含水量达到指标，在最后的沉降罐内安装高压电极，使油水在电场下分离。外输原油的含水量要求不大于0.5%。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条