2) Bridge plug
桥塞
1.
Application of the intromittent bridge plug in quadric well cementation;
可插入式桥塞在二次固井中的应用
2.
Development and application of a new removable bridge plug;
一种新型可取式桥塞的研制与应用
3.
Test and study of model Y455-115 bridge plug;
Y455-115型桥塞试验研究
3) Hot Bridge
热桥
1.
Research on the Hot Bridge Effect of Metal Studs in the SPU Insulation System;
金属龙骨在喷涂聚氨酯硬泡外墙外保温系统中的热桥效应研究
2.
This paper points out that the cause of emerging varying degrees hot bridge is that thermal insulation property of living building envelope is lower in our country, and it provides a solution by adopting insulation outside modes and a computing method to check temperature of surface on hot bridge.
指出我国采暖居住建筑围护结构保温水平低是产生不同程度热桥的原因,给出采用外保温方式的解决办法以及校核热桥部位内表面温度的计算方法。
3.
The hot bridge effect of steel stud on energy efficiency in the external insulation system of spraying rigid polyurethane foam(SPF) with decoration panel was clarified,and the influence of the air lay located in the external insulation system of SPF with decoration panel hanging on steel stud on wind resistance performance was described.
主要阐明了喷涂聚氨酯硬泡外保温系统中外挂装饰板所使用的龙骨产生的热桥效应以及由于龙骨外挂装饰板材所产生的空气层对系统抗风压性能的影响。
4) thermal bridge
热桥
1.
Experimental study on thermal bridge of energy efficient envelops in hot summer and cold winter areas;
夏热冬冷地区节能围护结构热桥实验研究
2.
Research on steady-state heat transfer calculation of thermal bridge in building envelopes;
建筑围护结构中热桥稳态传热计算研究
3.
Order reduced model of building thermal bridge dynamic additional heat loss;
建筑热桥动态附加能耗减秩模型
5) heat bridge
热桥
1.
Effect of heat bridge on energy saving in construction of block structure in freezing area;
热桥对严寒地区砌体结构建筑节能效果的影响
2.
In order to achieve the three-step energy-saving of residential buildings, besides the limited value of heat transfer coefficient for building envelopes and window-to-wall ratio with different orientations should be met, the shape coefficients and insulating structure of heat bridge should be regarded as key points in design of residential buildings with three-step energy-saving.
要实现居住建筑三步节能,除了要满足建筑各围护结构传热系数限值及各朝向的窗墙比外,体型系数及热桥部位的保温结构也应作为三步节能居住建筑设计的要点。
3.
In order to conform the energy-saving and heat preservation of the residence building with the cold weather in the north-east part of China,an analysis of the common heat bridge section was made,the local heat preservation measures were studied so that the energy-saving design can be developed.
为了使民用住宅节能保温设计与东北地区严寒气候相适应,保证室内良好的热环境要求,并符合国家节能设计规范,提高开发商投资效益,本文对住宅墙体中常见的热桥部位进行分析,并研究了局部保温的措施,结果表明:保温构造层的连续性,可防止在保温层断续处出现传热薄弱,该做法有利于节能设计的发展。
6) bridge formation
桥型堵塞
1.
Based on the information of this analysis and process of bridge formation,relatively small force conditions are worked out whic.
用多孔介质模拟地层,以胶体微粒作为堵塞颗粒,在前人研究的基础上建立微粒桥型堵塞的微观模型,研究利用超声波辐射的方法解除多孔介质中堵塞微粒的作用机理,分析超声波作用下管孔中微粒的受力情况和微粒在没有超声波作用下形成稳定桥型堵塞状态下的受力情况,并根据微粒受力情况和形成桥型堵塞过程,分析出微粒脱落时所需外在拉力。
补充资料：威尔士塞文桥
威尔士塞文桥
英国威尔士塞文桥，主跨988米，扁平钢箱梁，梁高3.0米，桥宽22.86米。箱梁两侧梁高的上三分点处各设有4.5米宽的鱼鳍形的伸臂人行道，吊杆在顺桥向的倾角为正30度，钢塔柱高121.92米，1960年建成。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。