说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> γ-氯丙烯
1)  γ-dichloropropene
γ-氯丙烯
1.
The γ-chloropropyldimethylchlorosilane was prepared with γ-dichloropropene and allyl chloride by platinum catalyst.
γ-氯丙烯与二甲基氯硅烷为原料,在铂催化下合成γ-氯丙基二甲基氯硅烷。
2)  γ-Methacryloxpropyldimethylchlorosilane
γ-(甲基丙烯酰氧基)丙基二甲基氯硅烷
3)  allyl chloride
氯丙烯
1.
Eeffect of solvent on epoxidation of allyl chloride with hydrogen peroxide and titanium silicalite;
TS-1催化氯丙烯环氧化反应过程中的溶剂效应
2.
Development and utilization of allyl chloride and its derivatives;
氯丙烯及其衍生产品的开发和利用
3.
Correlation of nerve conduction velocity and lipid peroxidation induced by allyl chloride in rat sciatic nerve;
氯丙烯诱导的大鼠坐骨神经传导速度和脂质过氧化相关性
4)  allyl chloride
烯丙基氯
1.
Allylsucrose was prepared by the reaction of sucrose with allyl chloride as the etherification agent in the presence of NaOH as an activating agent.
以蔗糖为原料,NaOH为活化剂对蔗糖进行活化预处理,烯丙基氯为醚化试剂,制备了烯丙基蔗糖(AS)。
2.
Flame retardant bis(4-allyloxy-3,5-dibromophenyl)sulfone(ATBS) with high yield and high mass fraction was obtained by etherization of bis(4-hydroxy-3,5-dibromophenyl)sulfone(TBS) with allyl chloride in the presence of alkaline medium and under low pressure(gauge pressure 0.
用四溴双酚S(TBS)和烯丙基氯为原料,在NaOH水介质中,低压条件下(表压0。
3.
High yield and purity flame retardant bis-(4-allyloxy-3,5-dibromophenyl)sulfone(ATBS) was obtained by allyl-etherizing bis-(4-hydrxy-3,5-dibromophenyl)sulfone(TBS) with dropping allyl chloride in aqueous NaOH in the presence of cetyltrimethylammonium bromide(CTAB) or other surfactants.
用四溴双酚S(TBS)为原料,以滴加方式加入醚化剂烯丙基氯,在NaOH水溶液中用十六烷基三甲基溴化铵(CTAB)催化醚化法和其它表面活性剂促进醚化法合成了收率、纯度均较高的阻燃剂四溴双酚S双烯丙基醚(ATBS)。
5)  acryloyl chloride
丙烯酰氯
1.
Synthesis of copolymer from acryloyl chloride graft on polyvinyl alcohol;
丙烯酰氯接枝聚乙烯醇纤维的合成及光谱研究
2.
Coupling reaction of living butadiene-styrene copolymers coupled with acryloyl chloride;
丙烯酰氯偶联活性丁苯共聚物
3.
A bioactive monomer 3, (± )-(E)-1-(2,4- dichlorophenyl)-2-(1,2,4-triazol-1-yl)-4,4-dimethyl-1-penten-3- ol-acrylate, was synthesized by reacting diniconazole 1 with acryloyl chloride 2, and its structure was confirmed by IR, MASS and 1H NMR spectroscopy.
以杀菌剂烯唑醇1为底物与丙烯酰氯2反应合成了具有生物活性的可聚合单体(±)-(E)-1-(2,4-二氯苯基)-2-(1,2,4-三唑-1-基)-4,4-二甲基-1-戊烯-3-醇丙烯酸酯3,以IR,MASS和1H NMR对其化学结构进行了表征。
6)  allylchloride
烯丙基氯
1.
The synthesis of allylamine based on the method of Delépine amine by the reaction of allylchloride in ethanol and hexamethylenetetramine in the presence of KI was investigated.
以Delépine伯胺制备方法为依据,用无水乙醇代替氯仿做溶剂,通过烯丙基氯与乌洛托品反应制备烯丙基胺。
2.
Butadiene was polymerized to some extent in the presence of binary catalyst system NdCl33iPrOHAlEt3 in toluene and the allylchloride was then added to the solution in order to cyclize the formed polybutadiene and cyclopolymerize the unreacted butadiene monomers.
采用NdCl3·3i-PrOH-AlEt3稀土催化剂进行丁二烯的顺式聚合,在聚合过程中引入烯丙基氯,进行分子内环化反应以及单体的环聚反应。
3.
The technological conditions of the synthesis of dimethyl diallylammonium chloride were studied taking allylchloride, dimethylamine and Aqueous solution of caustic soda as raw material.
本文以烯丙基氯、二甲胺、氢氧化钠为原料,探讨了合成二甲基二烯丙基氯化铵的工艺条件,研究了反应温度、反应时间、烯丙基氯加入方式对产物收率的影响,在一定的反应条件下,收率达85%以上。
补充资料:甲基氯硅烷
      甲基硅烷上与硅相连的氢被氯取代的一类产品,其中有工业意义的为二甲基二氯硅烷〔(CH3)2SiCl2〕、甲基三氯硅烷(CH3SiCl3)、甲基二氯硅烷(CH3SiHCl2)和三甲基氯硅烷〔(CH3)3SiCl〕。主要由一氯甲烷制得(见甲烷氯化物)。常温下均为无色、透明液体,沸点分别为70.0℃、66.4℃、41.0℃和57.9℃,能燃烧,易水解。是合成硅油、硅橡胶和有机硅树脂的原料。
  
  甲基氯硅烷的生产方法有间接法和直接法两种。现在工业上均采用直接法,它由美国E.G.罗乔于1940年所发明,生产上以铜或铜盐为催化剂,在300℃左右使一氯甲烷与硅粉直接反应。这是一个复杂的非均相反应。反应所得混合物主要含二甲基二氯硅烷(约70%),其次是甲基三氯硅烷,还有三甲基氯硅烷、甲基二氯硅烷等。产物通过精馏可得纯品。由于反应放热,温度控制极为重要,现大多数采用流化床反应器。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条