1) PicoBlaze soft-core processor
PicoBlaze软核处理器
2) soft core processor
软核处理器
1.
In consideration of the big volume of vehicle plate recognition system of traditional personal computer plus algorithm design,which can not satisfy the requirement of portable and open application,Nios Ⅱ soft core processor is used to design a graphic system of vehicle plate automatic recognition.
针对传统的PC机+算法设计的车辆牌照识别系统体积大,不能满足便携和露天使用的要求,采用NiosⅡ软核处理器在FPGA(FieldProgrammableGateArray,现场可编程门阵列)上设计了一种车辆牌照自动识别的片上系统。
2.
The system is mainly constituted by Cyclone Ⅱ FPGA which Nios Ⅱ soft core processor embedded in,and audio encode and decode chip.
系统主要由CycloneⅡFPGA内嵌NiosⅡ软核处理器及音频编/解码芯片构成;通过构建嵌入式Linux操作系统来实现对音频信号的采集和回放处理。
3) soft-core processor
软核处理器
1.
As for the situation of the 1553B bus interface chip monopolized by fremdness at present,the embedded system design plan of implementing 1553B bus interface based on the NIOS Ⅱ soft-core processor of Altera Co is presented in this paper.
针对当前1553B总线接口芯片为国外所垄断的情况,提出了基于Altera公司NIOSⅡ软核处理器实现1553B总线接口的嵌入式系统设计方案。
2.
The Nios II processor is a configurable soft-core processor, as opposed to a fixed-microcontroller.
但与固定式微控制器不同,Nios处理器是一种可配置的软核处理器,“可配置”意味着其构建的系统,其性能或功能可以根据用户要求进行增减以满足性能或价格的要求。
4) soft processor
软核处理器
1.
Based on the introduction of the I2C protocol,this paper detaily intorduced the scheme of buliding soft processor with I2C bus interface by Nios2.
介绍I2C接口的协议标准,结合标准详细讲述了运用Nios Ⅱ建立具有I2C接口的软核处理器的方法。
2.
Based on SOPC techniques,such a modem comprised of configurable microblaze soft processor and rich peripheral interfaces is built under Xilinx EDK,both hardware and software platforms are configured flexibly,the OPB modem peripheral interface is designed with its corresponding driver implemented.
在Xilinx EDK(embedded development kit)集成环境下,以SOPC(systemon programmable chip)技术为支撑,构建了包含可配置软核处理器microblaze及丰富外设接口的短波跳频调制解调器,灵活配置其软硬件平台,设计了基于OPB(on-chip peripheral bus)片上总线的调制解调器外设接口及其驱动。
5) Dual-soft core processor
双软核处理器
补充资料：PI
聚酰亚胺是由4，4’-二氨基二苯醚与均苯四甲酸酐反应先得到高分子量且能溶于极性溶剂的预聚体——聚酰胺酸，然后在高温下脱水环化制得。不溶性聚合物．淡黄色粉末，细度＜250um，表观密度0．35。耐高低温，性能优异．在－269～400 ℃范围内保持较高的机械性能，热变形温度360℃(1.82MPa)。使用温度-240～260℃。耐辐射性极好。耐磨性良好，能耐大多数溶剂，但易被浓酸、浓碱水解。在沸水和蒸汽的长时间作用下能被破坏。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条