1) entrance shrinking angle
入口收缩角
1.
This paper is focused on the analysis of three nozzles with different entrance shrinking angle with FEM method.
文中运用有限元法对三种不同入口收缩角的喷嘴进行了分析。
2) entry natural converging half angle
入口自然收敛半角
1.
Numerical simulation for the entrance pressure drop and entry natural converging half angle of rubber componud
混炼胶入口压力降和入口自然收敛半角的数值模拟
3) angular constriction
角收缩
4) azimuthal pinch
角向收缩
5) shrinkage angle
收缩角
1.
The relation between mould cavities and plastic gears was obtained through calculation and the shrinkage angle and shrinkage rate were discussed.
通过对塑件成型制品的收缩规则和收缩特性分析,提出了塑料齿轮向"对称中心"收缩的概念,利用实例计算,得出模具型腔与塑料齿轮的关系式,并对收缩角和实际收缩率进行了阐述。
6) withdraw into a corner
缩入角落
补充资料：入口
1.进入嘴中。指饮食。 2.外国或外地区的货物运进来。 3.进入建筑物或场地所经过的门或口儿。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条