1) the belt built-up welding
管板带极堆焊
1.
Welding test on the belt built-up welding 304L to the 20MnMo forging pipe-steel
20MnMo锻件管板带极堆焊304L的焊接试验
2) strip surfacing
带极堆焊
1.
Magnetism conduct principle of trip surfacing was researched by simulating band electrode weld penetration state, analyzing the response of band electrode electric current to control magnetic field existence, the intensity, and the location conversion, and applying electronic techniques theory to analyze strip surfacing penetration control technique.
利用模拟带极堆焊状态下带极电流对控制磁场存在与否及强度、位置变化的反应,应用电工学原理分析带极堆焊磁控技术。
2.
In order to improve the productivity, strip surfacing with higher welding currents and wider strips are adopted, which leaded to poor bead characteristics usually.
带极堆焊中 ,为提高生产效率多采用宽带极、大电流 ,因而容易引起焊道成形不良。
3) strip cladding
带极堆焊
1.
And presents two overlay welding processes using strip to obtain a clad material: submerged (?)are strip cladding (SAC) and electric slag strip cladding (ESC).
而且也给出了获得堆焊材料的两种带极堆焊工艺:一种是埋弧带极堆焊(SAC);另一种是电渣带极堆焊工艺(ESC)。
2.
The paper describes strip cladding of dual phase steel,and maily tests cooling method s effect on the performance after weld.
介绍双相钢的带极堆焊,主要试验焊后冷却方式对性能的影响。
4) strip overlay welding
带极堆焊
1.
Using a microcomputer controlled strip overlay welding equipments the weldingprocess and the method of quality controlling of the weld are investigated for the electro-slagoverlay welding(ESW)with a strip of 75 mm×0.
利用微机控制的带极堆焊设备，进行了７５ｍｍ×０。
5) surfacing by fire cracker welding
躺板极堆焊
6) the surfacing plate of the tube sheet
管板堆焊面
1.
When the equipment runs, a bulge covered the range of 300mm appeals on the middle location of the surfacing plate of the tube sheet.
介绍了03033-04E003A/B-01型锅炉给水预热器的结构特点,针对在试运行过程中出现的管板堆焊面中心部位300mm范围内,出现鼓包并造成管与管板焊接部位将换热管拉出,并开裂造成管程与壳程出现泄露这一故障现象,分析了其损坏原因,制订了合理的修理方案,在原旧设备的基础上进行了修理。
补充资料：带极堆焊施工现场
带极堆焊施工现场
带极堆焊施工现场
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条