1) point slope
点斜率
1.
With the help of the point slope and the origin slope,this article makes an analysis of the three major leverage coefficients by EPS and Q exist linear relationship,and summarizes the generic formula of the leverage coefficient by the slope under the non-linear conditions,aiming to provide a new thought of leverage.
借助点斜率与原点斜率,通过剖析EPS与Q在线性条件下三大杠杆系数的计算过程,归纳出EPS与Q存在非线性关系时杠杆系数用斜率表示的通用公式,目的是提供一种计算杠杆系数的全新思路。
2) point-slope method
点-斜率法
1.
And the accuracy of using point-slope method and slope-proportion method to predict triaxial dynamic modulus was evaluated.
对SMA-13,Sup-20和Sup-253种沥青混合料进行了不同温度、围压和加载频率下的动态模量试验,并对利用点-斜率法和斜率-比例法(由中间点和由边缘点)预测三轴动态模量的效果进行了研究。
3) slope of zero
零点斜率
1.
An improved method which measures frequency through the slope of zero based on the cross-zero detecting is presented.
因此提出了一种改进的过零检测算法:零点斜率测频法。
5) origin slope
原点斜率
1.
With the help of the point slope and the origin slope,this article makes an analysis of the three major leverage coefficients by EPS and Q exist linear relationship,and summarizes the generic formula of the leverage coefficient by the slope under the non-linear conditions,aiming to provide a new thought of leverage.
借助点斜率与原点斜率,通过剖析EPS与Q在线性条件下三大杠杆系数的计算过程,归纳出EPS与Q存在非线性关系时杠杆系数用斜率表示的通用公式,目的是提供一种计算杠杆系数的全新思路。
6) slope of center
中心点斜率
1.
Then,it completes the detection of transistor s pins by checking area and find out the position of the transistor by checking slope of center.
先通过对目标图像的预处理和阈值分割完成图像的前期处理,然后通过面积法实现了集成块管脚的定位和检测,再用中心点斜率法完成了对集成块姿态的检测。
补充资料：点对点法
分子式：
CAS号：
性质：发射光谱分析中，将金属试样制成两个锥体状电极，分别作为光源的上下电极，彼此相对以电弧或火花法进行激发摄谱。该法因无辅助电极，所摄光谱中可无其伴存谱线。
CAS号：
性质：发射光谱分析中，将金属试样制成两个锥体状电极，分别作为光源的上下电极，彼此相对以电弧或火花法进行激发摄谱。该法因无辅助电极，所摄光谱中可无其伴存谱线。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条