1) plot aneurysm clipping
积削瘤
2) SWC
积屑瘤切削
3) accumulated burl
积瘤
1.
It was pointed out that more strict requirements had been seen with respect to the ability to resist accumulated burl of the coatings used for the surface protection of the annealing furnace of a.
随着对汽车板表面质量的要求不断提高,对退火炉炉辊表面喷涂层抗积瘤性的要求也随之提高。
4) cutting volume
切削体积
1.
On the basis of description of PDC-cutter geometry,in considering overlaps among cutting trajectories of cutters caused by angular position differences while rotary drilling,a computation method of cutting volume is developed.
在PDC钻头切削齿几何描述的基础上,考虑到钻头旋转钻进时因切削齿周向角不同,即切削次序不同而造成的相互覆盖,建立了切削体积的计算方法和利用线性规划进行PDC钻头等切削体积布齿优化设计的方法,并编制了计算机程序。
2.
Accurate cutting volume is necessary to PDC bit optimization design and dynamics analysis.
PDC钻头优化设计和力学分析都需要准确计算切削体积,本文在PDC钻头切削齿几何描述的基础上,考虑到钻头旋转钻进时因切削齿周向角不同,即切削次序不同而造成的相互覆盖,建立了切削切削面积、切削体积的计算方法,编制了计算机程序,给出了计算实例。
5) cutting area
切削面积
1.
The calculating formulas of cutting area of single diamond grain when the diamond circular saw blade rotates along clockwise or counterclockwise with a constant rotational velocity as well as feeding with a constant speed are deduced, and the relationship between the cutting area of diamond grain and sawing parameters is analyzed.
推导了金刚石圆锯片以等角速度作顺时针或逆时针旋转、同时作匀速进给运动时单颗金刚石磨粒切削面积的计算公式 ,并分析了磨粒切削面积与锯切参数的关
2.
The composition of velocity law of the points in kinematics is led into the solving of the cutting area of single diamond grit.
引进运动学中的点速度合成定理 ,求解单颗金刚石磨粒切削面积 。
3.
The factors,which include cutting area,contact arc length,back rake angle,rock strength against drilling and worn height of cutter,on the forces on PDC cutter were analyzed.
模拟钻头上的切削齿的不同的切削断面形状、重叠切削状态及磨损状态,利用PDC切削齿对多种岩样进行了切削试验,研究了切削面积、接触弧长、切削齿后倾角、岩石抗钻强度、切削齿磨损高度等因素对PDC切削齿受力的影响规律。
6) equivolume cutting
等体积切削
补充资料：积积
1.长久累积。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条