1) strong preservation
强保留
1.
According to a relation between completeness of Abstract interpretations and strong preservation of Abstract model checking,the problem of minimally refining Abstract model in order to make it strongly preserving CTL can be formulated as a minimal Abstract domain refinement in Abstraction interpretation in order to get completeness,and this refined complete Abstract domain always exists.
给定具体Kripke结构和时序描述语言CTL,基于抽象解释框架以及完备抽象解释和性质强保留之间的关系,抽象模型最小精化使得CTL性质强保留,可转换为抽象解释中抽象域的最小完备精化,并且总是存在抽象域的最小完备精化。
2) strength retention rate
强度保留率
1.
Preparation of modified acrylic ester emulsion with monomer styrene(St),epoxy resin(WSR6101),diallyl phthalate(DAP),and their strength retention rate on fiberglass mesh was investigated in this study.
讨论了由苯乙烯(St)、环氧树脂(WSR6101)、邻苯二甲酸二烯丙酯(DAP)单体改性制得的丙烯酸酯乳液对玻璃纤维网布的强度保留率的影响,并通过FT-IR、光学显微镜等观测方式对树脂膜和玻璃纤维网布进行表面分析,表明在80℃的5%NaOH水溶液的作用下,树脂涂层发生了物理化学变化,同时碱液能够穿透树脂涂层并直接侵蚀玻璃纤维基体,导致粘接性能下降,从而降低了网布的机械强度。
3) strength retention
强力保留率
1.
Cotton fabric strength retention percentage and wrinkle recovery angle(WRA) were analyzed with orthogonal analysis, and the best ratio of BTCA solution was determined.
探讨自制防皱整理剂BTCA在棉织物整理中的应用,运用正交分析法对棉织物断裂强力保留率以及折皱回复角变化进行研究,确定BTCA整理液的最佳配比。
4) break strength retention
强力保留率
1.
Results show that the concentrations of resin and magnesium chloride have more influence to both wrinkle recovery angle and break strength retention,of which the dosage of resin is the most remarkable factor affecting the wrinkle recovery angl.
分析表明,树脂浓度和催化剂MgCl2的浓度对折皱回复角和强力保留率的影响均较大,其中树脂用量对折皱回复角的影响最为显著。
2.
At the same time, regular finishing methods can t balance the matter between wrinkle recovery angle and break strength retention.
但是，常规整理方法往往会出现折皱回复角和强力保留率不能兼顾的问题。
5) Retention rate of tensile strength
拉伸强度保留率
6) breaking strength retention
断裂强力保留率
1.
8°,breaking strength retention both in warp and weft 63.
8°;经纬向的断裂强力保留率分别为63。
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条