1) small transmogrification thin sheet
小挠度薄板
1.
This paper uses the small transmogrification thin sheet theory to analyze and calculate the even covers’ acting force of preheat wheel, introduces the calculation method of this kind of even cover to apply rules of AD pressure vessel, and resolves the calculation problem of this kind of even cover.
基于小挠度薄板理论对预热轮两端平盖的受力进行了分析计算,介绍了运用AD压力容器规范对此类平盖的计算方法,解决了此类平盖的计算问题。
2) sheet deformation
薄板挠度
3) the small deflection bending theory of thin plate
薄板小挠度弯曲理论
1.
Which is based on the small deflection bending theory of thin plate, its analytical formula is derived, the influence of some parameters on which is analyzed comprehensively.
分析了直杆式光纤水听器探头的静力灵敏度,基于薄板小挠度弯曲理论导出了其静力灵敏度计算的解析公式,讨论了光纤水听器探头灵敏度的影响因素,并且利用ANSYS进行了模拟分析,数值解与解析解比较吻合。
4) bending of thin plates with large deflections
大挠度弯曲薄板
1.
Reciprocal theorem for non-linear elasticity with finite displacements in rectargular cartesian coordinates is established and reciprocal theorems for bending of thin plates with large deflections are given by Fubaolian.
付宝连建立了直角坐标系,建立了有限变形非线性弹性力学的功的互等定理并给出了大挠度弯曲薄板的功的互等定理。
2.
Reciprocal theorem for non-linear elasticity with finite displacements in rectargular cartesian coordinates is established in this paper and reciprocal theorems for bending of thin plates with large deflections are given.
建立了直角坐标系有限变形非线性弹性力学的倒易定理并给出了大挠度弯曲薄板的倒易定理。
5) thin plate flexibility
薄板挠曲
6) flexible and thin tube sheet
挠性薄管板
1.
Applying the theory of finite element, analyze the stress of the waste heat boiler, analyze detailedly the intension of the stress of the flexible and thin tube sheet, by the MSC.
介绍了日产125 t合成氨系统转化气挠性薄管板废热锅炉的结构,利用有限元理论通过MSC。
补充资料：薄板
薄板
sheet
b0Obon薄板(sheet)厚度为0.2一4mm、以单张定尺供应的板材。生产方法主要分为热轧和冷札两类。现代热连轧机生产(见热连札宽带钢生产)的薄板最小厚度为1.Zmm。以叠轧方式热轧(见登札薄板生产)则能生产最小厚度为0.28mm的叠轧薄板。现代冷轧机生产的薄板，厚度更薄(0 .Zmm以下)且尺寸公差更为严格。 (李生智李隆旭)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条