1) adhesive width
粘结宽度
1.
Based on design requirements of silicone structural adhesive width specified in the technical code for curtain wall and experimental results, the article analyses effects of increasing the width on performance of the adhesive and puts forward a solution to decrease the width of the adhesive by selecting quality adhesive and increasing designed strength of silicone structural adhesive.
围绕《玻璃幕墙工程技术规范》的硅酮结构胶粘结宽度设计要求,结合硅酮结构胶粘结宽度变化的实验数据,分析讨论了粘结宽度增加对结构胶性能的影响,提出了在保证幕墙安全性的前提下,通过选用高性能硅酮结构密封胶、提高硅酮结构密封胶的强度设计值来减小结构胶粘结宽度的解决方案,并简要介绍了相应的工程应用概况。
2) Mucosa Width
粘膜宽度
3) bond strength
粘结强度
1.
Effect of thickness on bond strength of soft liner materials for denture;
厚度对义齿软衬材料粘结强度的影响
2.
Study of chemical etching on increasing bond strength of light-cured composite to pure titanium;
用酸蚀法提高纯钛与光固化冠桥树脂粘结强度的研究
3.
Bond strength between tooth and base bracket with two bracket base designs: An in vitro comparative study.;
两种底板托槽体外粘结强度的对比研究
4) Adhesive strength
粘结强度
1.
The putty shows a good property of waterproofing and adhesive strength.
制备了一种新型的外墙用粉体腻子,通过在配方中添加胶粉提高了腻子的耐水性能和粘结强度;干粉腻子中的胶粉与水泥水化物形成空间立体网状结构,使得腻子成为一个致密的整体;讨论了填料对腻子性能的影响,通过加入各类助剂,有效提高了腻子的防开裂性、抗渗性、施工性等性能。
2.
The factors affecting the film adhesive strength were investigated,including hydrolysis solvents,hydrolysis time,concentration of solution,and ageing temperature.
研究了水解溶剂、水解时间、溶液浓度和固化温度对硅烷膜与基体粘结强度的影响,揭示了结合机理。
3.
The adhesive strength and thermal stability of acrlamide-acrylate copolymer un- der the conditions of high temperature were studied.
扼要介绍了丙烯酰胺—丙烯酸酯共聚树脂的溶解性能,粘结性能,以标准砂为粘结对象,研究了共聚树脂的常温粘结强度,热稳定性,高温热强度等。
5) adhesion strength
粘结强度
1.
In order to enhance interfacial adhesion strength,RFL(resorcin-formaldehyde-latex) is used to treat the surface of PET cord.
帘子线被广泛应用于橡胶增强复合材料的骨架材料,为提高涤纶帘子线与橡胶的粘结强度,通常采用RFL(间苯二酚—甲醛—胶乳)对帘子线表面进行预处理。
2.
The effect of surface corona discharge modification of UHSPE fiber on interfacial adhesion strength of UHSPE fiber/epoxy resin was investigated.
介绍了一种新型高性能有机纤维———超高强度聚乙烯(UHSPE)纤维的性能及应用,研究了其表面经电晕放电改性对UHSPE纤维 环氧树脂界面粘结强度的影响。
3.
The stability of hydrolysis and adhesion strength of PU are not good.
聚氨酯的水解稳定性较差,粘结强度偏低。
6) resin-bonded stiffness
粘结刚度
1.
Secondly,the relation between longitudinal wave propagation velocity and resin-bonded stiffness of full length anchoring bolt is simulated.
针对煤矿锚杆支护的特点,首先从理论上研究应力波在托板处、锚固开始位置、锚固结束位置的反射和透射规律;然后模拟纵波在全长锚固锚杆内传播速度与树脂-围岩粘结刚度之间的关系;最后在锚杆支护实验室进行了预应力锚杆支护实测对比试验。
补充资料：粘结
1.谓黏合连结的作用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条