1) sludge volume loading
污泥容积负荷
1.
The effect of height-diameter ratio(H/D),sludge volume loading(SVL) and nutritive proportion(NP) on the formation of AGS was studied.
用普通絮状污泥作为接种污泥,用SBR作为反应器,分析了高径比、污泥容积负荷以及营养比例(BOD5:N:P)等因素对好氧颗粒污泥形成的影响。
2) sludge loading
污泥负荷
1.
The effect of the BPA-sludge loadings on the BPA removal was investigated, and the contributions of sludge adsorption and biodegradation to removal were analysed.
考察了不同双酚A污泥负荷对双酚A去除的影响,以及污泥吸附和生物降解对去除的贡献。
2.
Comparison of removal rates was conducted with similar target compound-sludge loadings.
采用不主动排泥的运行模式,在相同污泥负荷条件下,对比研究了膜-生物反应器(MBR)与传统活性污泥反应器(CASR)对两种典型内分泌干扰物——双酚A(BPA)与壬基酚聚氧乙烯醚(NPnEO,n=1～4)的去除效果。
3.
sludge loading,pH and DO.
方法采用动态实验装置(膜生物反应器),通过对BOD、MLSS等的检测,研究污泥负荷、pH和DO对胞外聚合物合成的影响。
3) sludge loading rate
污泥负荷
1.
Effect of sludge loading rate on the formation of sludge granules in UASB reactors;
污泥负荷对上流式厌氧污泥床中颗粒污泥快速形成的影响
2.
The results indicated that the phenomenon of sludge washed away was mitigated obviously when the sludge loading rate reached to 0.
试验结果表明:该废水污泥负荷达到0。
4) sludge load
污泥负荷
1.
Optimization of sludge load in sludge water treatment system;
排泥水处理系统污泥负荷优化的中试研究
2.
A pilot-scale sequencing batch reactor (SBR) with a 12 L treating volume is conducted to treat high lipid-containing industrial wastewaters, and the main microbiological characters of the SBR process including active sludge volume index (SVI), the volume load (Nv), and the sludge load (Ns) are investigated.
小试研究了采用规模为12L的间歇式活性污泥法(SBR)生物反应器处理高浓度工业油脂废水,并分析了油脂废水降解过程中污泥体积指数、容积负荷、污泥负荷等的微生物学特性变化。
3.
Study was made previously on the effect of sludge load on filamentous sludge bulking, based on which experimental study was then conducted on the recovery of settleability of bulking sludge happening at low sludge load operation.
在前期已进行的污泥负荷对丝状菌污泥膨胀影响的研究基础上 ,对低污泥负荷下发生的污泥膨胀进行了污泥沉降性能恢复的试验研究。
5) volumetric loading
容积负荷
1.
8%,and the COD removal had a negative relativity with volumetric loading rate;the average COD of the effluent was 2596 mg/L,but had a poor biodegradability,with an average BOD5/COD ratio of 0.
在进水原生渗滤液COD浓度在17 157~33 599 mg/L时,通过控制进水量,调节停留时间,控制反应器容积负荷在6。
2.
The effects of toxic and harmful matters, alkalinity and volumetric loading on the anaerobic biological treatment were studied and discussed through an experimental comparison between diluted influent water and undiluted influent water.
通过进水稀释与不稀释的实验对比,分析探讨了有毒有害物质、碱度、容积负荷等对厌氧生物处理的影响。
3.
The main objective of the experiments is to study the influence of gas to liquid ratio,hydraulic and influent organic loading,carbon and nitrogen mass ratio and the bed material height on the volumetric loading of BAF operated under lower aeration conditions.
针对南方特有的低浓度生活污水,研究了在低曝气条件下,气水比、水力负荷、进水有机负荷、碳氮比、填料层高度等因素对曝气生物滤池容积负荷的影响。
6) volume loading
容积负荷
1.
The results show that when the volume loading of the MBR is 7—10 kg·m-3·d-1, the removal rates of COD, NH4-N and TN are up to 90%, 80% and 65%, respectively.
结果表明,当膜生物反应器的进水COD容积负荷7～10kg。
2.
The influences of start-up time,maximum volume loading,granular sludge production process,alkalinity requirement and trace elements on the treatment of landfill leachate by UASB reactor were investigated.
采用上流式厌氧污泥床(UASB)处理垃圾渗滤液,通过试验研究了UASB反应器处理垃圾渗滤液的启动时间、最大容积负荷、颗粒污泥的产生过程、对碱度的要求及微量元素对运行的影响。
3.
The influence of different COD volume loading on removal efficiency of urban domestic sewage in suspended carrier biological fluidized bed reactor was investigated.
采用悬浮载体生物流化床工艺处理城市生活污水,考察了容积负荷对其处理效果的影响。
补充资料：污泥负荷
分子式：
CAS号：
性质：生物处理构筑物(如曝气池或其他构筑物)单位时间内单位重量污泥所能去除的有机物量。常用BOD5为kg/[kg(污泥)·d]或kg/[kg(MLSS)·d)来表示。它是曝气池或其他生物处理构筑物有机负荷的一种表示方法。
CAS号：
性质：生物处理构筑物(如曝气池或其他构筑物)单位时间内单位重量污泥所能去除的有机物量。常用BOD5为kg/[kg(污泥)·d]或kg/[kg(MLSS)·d)来表示。它是曝气池或其他生物处理构筑物有机负荷的一种表示方法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条