说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 混凝土实际应力
1)  actual stress of concrete
混凝土实际应力
2)  prestressed concrete solid pile
预应力混凝土实心方桩
3)  concrete stress
混凝土应力
1.
When the deformation method was used for concrete stress calculation,it was assumed that the stress increased suddenly at each stage,and such an assumption led to certain errors.
采用变形法计算混凝土应力时,假设应力在各个时段内以突变形式增加,并对这种假设带来的误差进行了分析。
2.
The measurement of the concrete stress distribution and the circumferential deformation of the cell body in oval sludge digester of Zhangzhou water treatment plant are carried out on site.
对漳州水处理厂卵形消化池工程进行了混凝土应力测试及张拉引起的池壁环向变形测试 ,并将测试结果和有限元计算结果作了对比分析 ,对正常使用时的池壁受力情况进行了评
4)  tri-axial stress concrete
三向应力混凝土
1.
Through initial analysis of this paper points out that the carrying capability of the constituent unit can be promoted by using self-stressing concrete as the core part; the applications of concrete expansive agent to tri-axial stress concrete and notice items during constructing process are also be presented in this paper.
本文通过对三向应力混凝土结构特点的简单分析,指出核心采用自应力混凝土能够提高构件的承载能力;介绍了混凝土膨胀剂在三向应力混凝土中的应用情况和施工中应该注意的事项。
5)  prestressed concrete
预应力混凝土
1.
Calculation method and influencing factors to secondary axial force for prestressed concrete frame beam;
预应力混凝土框架梁次轴力计算及其影响因素分析
2.
Experiment study on seismic behavior of bonded prestressed and unbonded prestressed concrete flat beam frame;
有粘结和无粘结预应力混凝土扁梁框架抗震性能试验
3.
Research on the prediction of deflection for prestressed concrete beams based on neural network;
基于神经网络的预应力混凝土梁挠度预测研究
6)  concrete temperature stress
混凝土温度应力
补充资料:通用机械:预应力混凝土压力容器
用预应力混凝土制成的压力容器。20世纪50年代末期﹐法国用预应力混凝土压力容器作气冷反应堆的压力壳。以后许多国家均在气冷反应堆上采用预应力混凝土压力容器﹐设计压力已达6兆帕。由于轻水型反应堆和煤转化用的钢质压力容器的尺寸不断增大﹐越来越难以用钢制造﹐在运输上也有很多困难﹐工程界正在进行以预应力混凝土压力容器代替钢质压力容器的可行性研究。混凝土的抗压性能好﹐但抗拉性能很差。为使混凝土在承受拉应力时不破坏﹐在其内部埋入高强度钢缆或钢筋﹐然后对钢缆或钢筋施加预拉伸应力﹐使混凝土承受较高的预压缩应力。这样﹐当预应力混凝土容器内承受工作压力时﹐作用在混凝土筒壁上的拉应力便被预压缩应力所抵消﹐而混凝土不承受拉应力。在容器内壁有一层薄的钢制衬里﹐以防止介质泄漏。用于高温的容器﹐在衬里层上加有绝热层﹐以防止混凝土温度过高。预应力混凝土压力容器有两个显著优点﹕ 可采用普通的设备在现场施工建造﹐容器的尺寸不受限制。当金属压力容器因直径过大﹑器壁过厚等原因而无法运输或制造时﹐可选用预应力混凝土压力容器。 这种压力容器的破坏模式与钢制压力容器不同﹐它是逐渐破坏的。钢衬里如有泄漏﹐介质沿混凝土的渗透是一个较慢的过程。此外﹐钢缆是互不相连的﹐如果个别钢缆出现裂缝﹐裂缝不会由一根扩展到另一根﹐因而容器具有高度的安全性。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条