3) cavity pressure
液室压力
1.
Effects of key process parameters including the shape of pre-forming punch,corresponding pre-forming depth,and cavity pressure on the forming process of the finally formed parts were explored in multi-hydrodynamic deep drawing by using the finite element numerical simulation methods.
采用板多级充液成形方法对难成形复杂薄壁结构的飞行器零件进行了研究,利用有限元数值模拟的方法,分析了预成形凸模形状、预成形深度,以及液室压力等关键工艺参数对成形的影响。
2.
In this paper, aiming at the forming failure types of the sheet hydroforming of complicated aircraft aluminum part, effects of key process parameters including blank shape,cavity pressure etc.
针对某型号飞机铝合金复杂构件充液成形的失效形式,采用有限元数值模拟和试验的手段,研究了毛坯形状、液室压力等关键工艺参数对成形失效的影响,给出了铝合金复杂构件充液成形质量控制的措施,为此类型航空复杂构件的充液成形提供了技术指导。
4) Left ventricular pressure
左室压力
1.
The correlation study of left ventricular pressure changing on left atrium function studied with tissue velocity imaging under acute left ventricular ischemia;
组织速度显像对急性心肌缺血下左室压力变化与左房功能影响的相关性研究
5) Compartment pressure
间室压力
6) indoor pressure
室内压力
补充资料：髓核
髓核
nuelcus pulposus
为乳白色半透明胶状体，富于弹性，为椎间盘结构的一部分，位于两软骨板与纤维环之间。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条