2) inspection jig
检验夹具
1.
The development of the inspection jig for cone deflection gear serrated form;
圆锥变位齿轮齿形检验夹具的研制
3) measuring jig
测量夹具
1.
This paper analyse the influences of precision of bridge,measuring jig and so on to measuring accuracy, and discusses the improvements.
本文分析了电桥的精度、测量夹具等因素对测量结果准确性的影响,并提出了具体改进措施。
4) Test fixture
测试夹具
1.
The problem of measurements for power microstrip microwave devices is considered, and the LRL(LineReflectLine) method is used to deembed the S parameters from the microwave transistor test fixture.
考虑微带型微波功率器件的测量问题 ,运用 L RL (Line- Reflect- L ine)法对测试夹具去嵌入 ,待测件的散射参量可表为测量值的单值函数 ,消除了嵌入网络参量相位不确定性引入的误差 。
2.
At least three known standards are normally required for the full two-port test fixture calibration in vector network analyzers (VNA).
一般矢量网络分析仪(VNA)的双端口测试夹具校准,至少需要三个已知标准才能实现。
3.
,development of the special test fixtures and software for six kinds of plug-in unit has been accomplished.
雷达领域插件级设计的模块化、软件化、标准化、继承性的推广使得针床测试台的性能价格比得以提高,我们基于美国TERADYNE公司的"Spectrum 8852"自动测试设备,完成了6个品种插件的测试夹具、软件开发。
5) Fixture measurement
夹具测量
6) mix format detection
夹版检测
补充资料：检测
检验测定：质量～。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条