1) in-situ pressureless reaction
原位无压反应
1.
SiC/MoSi 2 composites with different volume fraction of SiC particles were prepared by in-situ pressureless reaction sintering and the influence of sintering technique on the product was analysised.
利用原位无压反应烧结方法制备了不同配比的SiC/MoSi2复合材料,分析了烧结工艺对产物的影响,研究了原位生成的SiC颗粒对MoSi2基体材料室温力学性能和显微结构的影响。
2) warm compressed in-situ reacted process
温压-原位反应法
1.
C/C-SiC braking composites were fabricated by warm compressed in-situ reacted process(WC-ISR) with short carbon fibers,graphite powder,Si powder and resin.
以短炭纤维、炭粉、Si粉、树脂和粘结剂为原料,采用温压-原位反应法(WC-ISR)制备C/C-SiC制动材料,研究该材料的压缩性能及其破坏机理。
3) molding-in suit reaction
模压-原位反应法
5) in-situ reaction
原位反应
1.
Preparation of polyester/nano-ZnO composites by in-situ reaction;
原位反应合成聚酯/纳米氧化锌复合材料
2.
Fabrication of Al_2O_3-TiC/Al Composites by In-situ Reaction;
原位反应法制备Al_2O_3-TiC/Al复合材料
3.
In-situ reaction and phase composition design of monolithic refractories;
不定形耐火材料中的原位反应与相组成设计
6) in situ reaction
原位反应
1.
The room and elevated temperature mechanical properties,and fracture mechanism of the composites fabricated by in situ reaction method in the Al-TiO2-C system were studied.
讨论了Al-TiO2-C反应系原位反应合成铝基复合材料的常温和高温拉伸性能及其断裂机理。
2.
The TiN/Al2O3 composites were synthesized by in situ reaction using Al and TiO2 as starting materials,which were high energy milled and hot pressed.
结果表明:在球磨过程中粉料吸附并溶解了N2气,在后续热处理中原位反应形成了Ti2AlN相,当温度升高到一定程度时分解形成TiN,这有助于材料的致密化并使其力学性能提高。
3.
VCp/Fe composite was produced by in situ reaction,studied the influence of heat treatment on its structure and properties.
通过原位反应法制备了VCp/Fe复合材料,研究了热处理对其组织和性能的影响。
补充资料：原位
分子式：
CAS号：
性质：源于拉丁语。指在原来的，正常、自然的部位或位置。
CAS号：
性质：源于拉丁语。指在原来的，正常、自然的部位或位置。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条