2) U-Nb alloy
U-Nb合金
1.
The feasibility of reduced-friction coating against U-Nb alloy made by plasma spray technique was investigated.
探讨了用等离子体喷涂方法制备改善与U-Nb合金之间摩擦性能的减摩层的可行性。
3) hypoeutectoid uranium niobium alloy
亚共析U-Nb合金
1.
The microstructure of hypoeutectoid uranium niobium alloy treated by different heat treatment was studied by optical microscopy (OM), scanning electron microscopy (SEM), transmission electron microscopy (TEM) technologies.
利用金相显微镜(OM)、扫描电镜(SEM)、透射电镜(TEM)研究时效处理对亚共析U-Nb合金显微组织结构的影响。
4) uranium-niobium
U-Nb
5) Cu-Nb alloy
Cu-Nb合金
6) Fe-Nb alloy
Fe-Nb合金
1.
The tested wire specimens of Fe-Nb alloys were carbonized with 0.
通过对A_1点以下温度的氢-苯混合气流处理,使研究的Fe-Nb合金丝试样渗入0。
2.
in chapter two, Snoek Peak, reinforced Snoek damping effect, B peak, SKK peak, K(e|^) peak and internal friction spectrum of iron based materials such as magnetic-mechanical damping are explained; later on, the preparation methods of Fe-Nb alloy materials, experimental methods and possible errors during experimental process and data processing are discussed.
随后,介绍了Fe-Nb合金的制备以及实验方法、手段和数据处理过程中可能存在的误差。
补充资料：[3-(aminosulfonyl)-4-chloro-N-(2.3-dihydro-2-methyl-1H-indol-1-yl)benzamide]
分子式：C16H16ClN3O3S
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条