1) converter bus voltage
换流母线电压
1.
For researching the interaction among converter buses in MIDC(Multi-Infeed Direct Current) system,the converter bus voltage interaction formula of MIDC is deduced based on power flow equation of AC/DC system.
为了研究多馈入直流系统中换流母线电压之间的相互影响,以交直流系统潮流计算为基础,推导得出了多馈入直流系统换流母线电压相互影响的关系式。
2) ?bus transfer voltage
母线转换电压
3) voltage switchover
母线电压切换
1.
Analysis of secondary voltage loss caused by 220kV bus voltage switchover
220kV母线电压切换引起二次回路失压事故分析
4) ?bus transfer current
母线转换电流
5) DC bus voltage
直流母线电压
1.
To make the servo system have the expected functions,it s especially important for selection of DC bus voltage in servo driver.
在伺服系统中要使系统能够满足所期望的性能,伺服系统驱动器直流母线电压的选择尤为重要。
2.
The direct torque control(DTC) system fed by TSMC was proposed that to control the inverter to implement DTC,and to control the rectifier to correct input power factor,or improve the performance of the DTC system by controlling input current space vector or the scope of DC bus voltage.
根据双空间矢量调制的缺点,提出了逆变环节采用直接转矩控制,整流环节控制输入电流矢量或直流母线电压来实现输入功率因数校正或提高电机系统性能的双级矩阵变换器供电的直接转矩控制系统。
3.
The reason about weakly performance at low speed-lower ratio of voltage signal-to-noise (SNR) was analyzed,and proposed a novel method-adjustable DC bus voltage,to enhance the SNR as well as to improve the low speed performance.
针对永磁同步电动机扩展卡尔曼滤波无传感器控制时低速性能不佳的问题,分析了低速性能不佳的原因——电压信噪比较小,并且提出了提高信噪比的方法——调节逆变器的直流母线电压,来改善系统的低速性能。
6) bus bar current transformator
母线电流变压器
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条