1) stainless slag steel
不锈渣钢
1.
Physical and chemical properties of 1～15 mm stainless slag steel were analyzed.
分析了1～15mm不锈渣钢的粒度及成分含量,并对1～15mm不锈渣钢的90t电炉利用工艺进行开发与研究。
2) stainless steel slag
不锈钢渣
1.
The feasibility of beneficial reuse of two kinds of stainless steel slag,electric arc furnace(EAF) slag and argon oxygen decarburization furnace(AOD) slag,and their pollution properties of heavy metals were studied.
研究了2种不锈钢渣——电炉(EAF)钢渣和转炉(AOD)钢渣可资源化利用和重金属污染特性。
2.
Oxide reagents were mixed in stainless steel slag.
往不锈钢渣中混入氧化物磨成粉体,通过分析其粒度分布与比表面积,用DTA曲线确定工艺制度,烧制了陶瓷坯体样品,得出了粉体必须在杂质含量<1%,Cr2O3在2%~3%之间,渣量不超过30%的情况下,才能烧制出吸水率与显气孔率符合基本性能要求的陶瓷坯体。
3) stainless steel ash cooler
不锈钢冷渣器
1.
This article summarize the technology of manufacture on stainless steel ash cooler,analyse and explain the key points in manufacture process.
针对不锈钢冷渣器的制造技术进行归纳和总结,对制造过程中的难点进行分析和说明。
4) stainless steel fibre bits
不锈钢纤维渣
5) stainless steel cutting slag
不锈钢切割渣
1.
Selective reduction of Ni and Cr from stainless steel cutting slag is performed with medium frequency induction furnace.
采用中频感应炉还原不锈钢切割渣,选择性回收其中的镍、铬金属,并研究了工艺参数对还原过程的影响。
6) stainless steel strip electro-slag cladding
不锈钢带极电渣堆焊
1.
This paper mainly expatiates the experimental analysis about the influence of the power characteristics,welding specification parameters,magnetic control technology and flux on the quality of the stainless steel strip electro-slag cladding.
本文主要阐述了不锈钢带极电渣堆焊中电源特性、焊接规范参数、磁控技术、焊剂等方面影响不锈钢带极电渣堆焊质量的试验分析,确定了合理的焊接工艺,试验得到了满意的效果。
补充资料：干渣渣
1.缺乏水分而呈渣屑的样子。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条