1) fast-extension performance
突伸性能
1.
Optimization on fast-extension performance of nose landing gear of carrier-based aircraft
舰载机前起落架突伸性能优化
2) tensile properties
拉伸性能
1.
Research on tensile properties and fracture mechanism of different sizes SiCP reinforced Cu matrix composites;
不同粒度SiC_P增强铜基复合材料拉伸性能及断裂机制的研究
2.
Effect of high temperature carbonization on the tensile properties of integrally-braided 5D carbon/phenolic composites;
高温炭化处理对三维五向碳/酚醛编织复合材料拉伸性能的影响
3.
Effects of Anodic Film on Tensile Properties of Die Casting Magnesium Alloy in Micro-arc Oxidation;
微弧氧化膜层对压铸镁合金拉伸性能的影响
3) tensile property
拉伸性能
1.
Experimental investigation on tensile property of stitching joint 3D braided composites;
缝合连接三维编织复合材料拉伸性能试验研究
2.
Tensile Property of High-viscosity Nylon 6 Film;
高黏度尼龙6膜拉伸性能研究
3.
Compound spinning of cashmere/wool/polyester and analysis of its tensile property;
羊绒/羊毛/涤纶复合纺及成纱拉伸性能分析
4) tensile strength
拉伸性能
1.
Influences of different samples on the examination results of tensile strength of polymerizer head;
不同试样对聚合釜封头拉伸性能检测结果的影响
2.
Experimental investigations of biaxial tensile strength of plant fiber textiles
植物纤维织物双向拉伸性能测试方法研究
3.
The tensile strength of angle-interlock woven fabric and the relationship between the tensile strengthpropertyand the structure of angle-interlockwoven fabric were studied.
介绍了角联锁织物的结构特点,采用小样箭杆织机织造了层数为2层、3层到9层的角联锁织物共8块,探讨了角联锁织物的拉伸性能与其结构层数之间的关系。
5) tensile behavior
拉伸性能
1.
Strain rate and temperature dependence of tensile behavior of Kevlar~964C fiber bundles;
Kevlar~964C纤维束拉伸性能的应变率和温度效应
2.
This model is adopted in tensile behavior investigation of .
为了研究混杂复合材料的混杂效应,该文建立了单向混杂复合材料拉伸性能的两级三维剪滞模型,第一级模型为纤维和树脂构成的纤维束两相材料体系,第二级模型为2种(或多种)纤维束组成的混杂复合材料体系。
3.
To avoid the bend portion and stress concentration, a pyrolysis under tension, as well as their effect on the tensile behavior of SiC yarns was studied.
先驱体法制备连续SiC纤维在烧成过程中有明显的失重和收缩行为,导致纤维在弯曲处应力集中,从而影响其单丝强度和束丝拉伸性能。
6) tensile performance
拉伸性能
1.
Research of tensile performance of 2D weave C/SiC compositesat high temperature
二维编织C/SiC复合材料高温拉伸性能研究
2.
The changes of hygroscopicity and tensile performance of wool fibers were studied after the treatment of high temperature steaming and high-temperature hot water cooking.
本文研究了羊毛纤维经高温蒸汽及高温水煮处理后的吸湿性能与拉伸性能的变化。
3.
This paper makes a exploration of tensile performance test methods for activated carbon fibers,makes preliminary study of the technical parameters such as preliminary tension,drafting rate,sample length and so on.
对活性碳纤维拉伸性能的试验方法进行了探讨,对试验时的初张力、拉伸速度、纤维试验长度等技术参数的确定进行了初步研究。
补充资料：拉伸倍率
分子式：
CAS号：
性质：又称拉伸比，拉伸倍数。高聚物经纺丝成形后的初生纤维经过拉伸工序后其长度与原长度的比值。通常以拉伸过程中纤维的输出速度与喂入速度之比表示。完整的概念是拉伸行为发生在两部分：一是喷丝头拉伸，即纺丝熔体或液体流出喷丝孔的线速度，与卷绕速度之比，二是上述的初生纤维拉伸。在工艺中此两种拉伸需恰当控制。
CAS号：
性质：又称拉伸比，拉伸倍数。高聚物经纺丝成形后的初生纤维经过拉伸工序后其长度与原长度的比值。通常以拉伸过程中纤维的输出速度与喂入速度之比表示。完整的概念是拉伸行为发生在两部分：一是喷丝头拉伸，即纺丝熔体或液体流出喷丝孔的线速度，与卷绕速度之比，二是上述的初生纤维拉伸。在工艺中此两种拉伸需恰当控制。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条