1) LiFePO4/C composite
LiFePO4/C复合物
1.
This paper determined Li+ content of LiFePO4/C composite by air-acetylene flame atomic Absorption spectrum method,recovery rate of standard series sample with Fe2+ and PO3-4 and without Fe2+ and PO3-4 were determinated.
采用空气-乙炔火焰原子吸收法测定了LiFePO4/C复合物中的锂含量,考察了不加基体和加入基体的两种标准系列的回收率;因为目前还没有LiFePO4的标准样品和标准分析方法,所以实验采用模拟标准样品考察了不同酸介质和不同酸用量的影响,并进行了Fe2+、PO34-、Cr3+、Mg2+、Mn2+、Co2+、Ni2+离子对测定锂的干扰实验。
2) LiFePO4/CaB6 composite
复合物LiFePO4/CaB6
1.
LiFePO4 was synthesized by solid sate reaction and LiFePO4/CaB6 composite with different contents of CaB6 was prepared by two different methods.
采用固相法合成了纯的LiFePO4,并通过两种不同的方法合成了不同CaB6含量的复合物LiFePO4/CaB6。
3) LiFePO_4/C
LiFePO4/C
1.
LiFePO_4/C powders were prepared by carbothermal reduction of Li_2CO_3 with FePO_4·H_2O,which was synthesized by aqueous precipitation from solution of FeSO_4·7H_2O and NH_4H_2PO_4 with H_2O_2 as the oxidizing agent.
2H2O,然后通过碳热还原得到LiFePO4/C。
2.
Microwave processing was used to synthesize LiFePO_4 and LiFePO_4/C.
用微波法制备了LiFePO4和LiFePO4/C材料。
4) BaFeSi/C composite
BaFeSi/C复合物
1.
A novel BaFeSi/C composite was prepared by mechanical ball milling, and lithium insertion reactions on the composite electrode were investigated by cyclic voltammetry ,charge-discharge measurements, XRD and XPS spectroscopy.
采用机械球磨法制备BaFeSi/C复合物,并考察了其作为锂离子电池负极材料的电化学性能。
5) anaphase-Promoting Complex/Cyclosome
APC/C复合物
6) high-density LiFePO4/C
高密度LiFePO4/C
补充资料：[3-(aminosulfonyl)-4-chloro-N-(2.3-dihydro-2-methyl-1H-indol-1-yl)benzamide]
分子式：C16H16ClN3O3S
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条