1) frictional resistance characteristic
摩擦阻力特性
1.
Whether we can correctly understand the frictional resistance characteristics of the modified dry fracturing fluid or not would influence the fracture technology\'s effective implementation.
对改良的干法压裂液这种非牛顿流体的摩擦阻力特性的正确认识,关系着干法压裂技术的有效实施。
2) viscous force of friction
粘滞性摩擦阻力
1.
But in actual experimental process,the viscous force of friction has influenc in the varying degree to the measurement result when the initial velocity of the slide block is different.
在气垫导轨上做碰撞实验,最大限度地减少了摩擦阻力的影响,但在实际的实验过程中,仍发现滑块的初速度不同时,粘滞性摩擦阻力对测量结果有不同程度的影响,为此在气垫导轨上增加了电子发射装置,较好地控制滑块的初速度和测量滑块的加速度,从而减小粘滞性摩擦阻力对测量结果的影响。
3) cohesive friction resistance
黏性摩擦阻力
1.
The velocity field,the pressure field and the cohesive friction resistance of every cylinder were calculated.
利用边界元方法对不同间距的五圆柱体绕流问题进行研究——即边界元方法在水利方面的应用,得到了不同间距的五圆柱体绕流的速度场、内点的压力场、边界的压力分布以及各圆柱体所受到的黏性摩擦阻力。
4) Frictional Resistance
摩擦阻力
1.
Influence of the frictional resistance for deadline anchor axis on weight indicator accuracy;
死绳固定器轴上摩擦阻力对指重表精度的影响
2.
Influences of frictional resistance on flow distributions of the dividing and combining manifolds;
摩擦阻力对分流和汇流联箱流量特性影响
3.
A method for lateral buckling analysis of tubing with frictional resistance in deviated wells was presented.
提出了在斜直井中钻柱正弦屈曲分析时对摩擦阻力的处理方法,给出了考虑摩擦阻力时的屈曲平衡方程,建立了相应的微分求积法列式,用微分求积法时平衡方程直接求解。
5) Friction resistance
摩擦阻力
1.
An experimental investigation on the flow and heat transfer of the narrow-gap annular tube vapor generators.Ⅱ.Friction Resistance.;
窄缝环形管内流动与传热实验研究 Ⅱ.摩擦阻力特性
2.
Based on the analysis of macrostructure and microstructure of the sample after ECAE, the influence of friction resistance between the die wall and the sample on the deformation of the sample billet was discussed.
通过对挤压后纯铝试样的宏观变形及微观形貌分析,探讨了ECAE过程中模具内壁与试样之间的摩擦阻力对试样变形的影响,得到了滞变区比例与挤压位移之间的关系。
3.
In daily mine ventilation work,we treat as airway friction resistance factor a constant.
在矿井通风业务实际计算中认为 :对于某特定巷道的摩擦阻力系数视为一定值 ,不考虑其随风流流向改变而改变。
6) friction force
摩擦阻力
1.
In this paper,the effect of friction force on metal forming parameters has been summarized based on some last research reports.
论文基于近期已发表的文献 ,综述了摩擦阻力对金属成形参数的影响。
2.
The paper introduces the method and principle of testing friction force between mould plates and strand on the slab caster.
介绍了板坯连铸机结晶器铜板与铸坯摩擦阻力的测试原理和方法，分析了铜板与铸坯之间的摩擦状态与摩擦阻
3.
What s more,the produced friction force and the added moment,which act on the transmission shaft,influence equipment performance and increase equipment load.
通过对齿轮联轴器工作时的运动和受力分析得知,当补偿轴向位移、径向位移和角偏差时,在接触齿面之间存在滑动摩擦,滑动速度较大,使齿轮联轴器容易磨损破坏;并且在传动轴上产生摩擦阻力和附加弯矩,影响设备性能,增大设备负荷。
补充资料：摩擦阻力
分子式：
分子量：
CAS号：
性质：见流体阻力。
分子量：
CAS号：
性质：见流体阻力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条