2) charge stripping efficiency
剥离效率
1.
The heavy ion beam energy,as well as the charge stripping efficiency,was calculated by using the charge state stripping formula and empirical formula of stable isotope mass number.
采用电荷剥离分布公式和稳定核质量数经验公式,对串列加速器升级工程提供的重离子束流能量和电荷剥离效率进行计算。
3) economic function of divestiture
剥离绩效
4) high production ripping
高效剥离
5) peeling-off stress
剥离应力
1.
Discussion on methods of calculating peeling-off stress in midspan of RC beams strengthened with FRP sheets;
关于FRP加固钢筋混凝土梁跨中剥离应力计算方法的讨论
2.
The factors influencing peeling-off failure and failure criterion are summarized,and the characteristics of several methods for calculating the peeling-off stress are discussed.
指出纤维复合材料加固混凝土梁跨中剥离破坏的影响因素和破坏准则,讨论几种计算剥离应力方法的特点,提出更为简单可靠的直接对剥离块体进行有限元分析的新思路,并给出算例。
6) peeling stress
剥离应力
1.
Analysis of the peeling stress at the end of the reinforced concrete beam with prestressed carbon fiber reinforced polymer sheet;
预应力CFRP布加固混凝土梁的端部剥离应力分析
2.
Based on the linear elastic theory, this paper presents a method for calculating the peeling stress at the sheeting end of a RC beam with a strengthening sheeting under linear distributed loads.
在弹性理论的基础上,推导了任意线性分布荷载作用下混凝土梁粘贴加强片材加固时,片材端部剥离应力的计算公式。
3.
The characteristics of distribution of the shearing stresses,as well as normal and peeling stresses which influence the quality of bonded wafers are discussed.
对影响晶片键合的剪切应力、正应力以及剥离应力的分布特性进行了讨
补充资料：剥离
分子式：
CAS号：
性质：橡胶涂层或橡胶层在外力作用下从基材(如金属或布)或另一橡胶层上分离的过程。和扯离不同的是：剥离是从界面的边缘开始的，而扯离是整个黏合面同时受力。根据剥离时拉力和黏合面之间所夹角不同，还可以分为180°剥离和90°剥离。
CAS号：
性质：橡胶涂层或橡胶层在外力作用下从基材(如金属或布)或另一橡胶层上分离的过程。和扯离不同的是：剥离是从界面的边缘开始的，而扯离是整个黏合面同时受力。根据剥离时拉力和黏合面之间所夹角不同，还可以分为180°剥离和90°剥离。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条