1) high carbon-bearing pellets
高含碳金属化球团
1.
The preparation of high carbon-bearing pellets and mechanism of the iron inner electrolysis treatment are introduced.
介绍了高含碳金属化球团的制备过程及其处理废水的机理-铁碳内电解法。
2) Metallized pellet
金属化球团
1.
As content ironore concentrates, not only high-quality metallized pellets, as electric furnace charge, wereobtained.
针对含锡锌砷超标的铁精矿采用球团直接还原工艺，既获得了供电炉炼钢用的优质金属化球团，又有效地脱除了产品中锻锌砷等杂质，脱除率达到90％以上。
3) metallic pellet
金属化球团
1.
The study on the bond mechanism of metallic pellet produced from Zn-Pb-bearing iron and steel plant dust with carbon shows that its compression strength is not only dependent on the shape and amount of iron phase but also on the size of hole in metallic pellet.
对含锌铅钢铁厂粉尘配碳球团，经还原焙烧后得到的高炉用金属化球团的固结机理进行了研究。
4) carbon-bearing pellet
含碳球团
1.
Under the condition of 1000~1200 ℃,study the effect of the carbon-bearing pellet strengths and metallization rate with different iron ore concentrate size,matching carbon ratio(carbon oxygen mol ratio),kind of additive and reduction temperature.
在1000～1200℃条件下研究了不同的矿粉粒度、配碳比、粘结剂、还原温度等对含碳球团强度及金属化率的影响。
2.
The carbon-bearing pellets made of zinc-bearing dust and sludge,iron concentrates and additive of agglomerant were reduced at 1 000~1 200 °C,the effects of different kinds of additive and reduction temperature on the strength and metallization rate of carbon-bearing pellets were studied.
将含锌尘泥、铁精矿及粘结剂混合造成的含碳球团在1050~1250℃条件下还原,研究了不同粘结剂、不同温度对其强度及金属化率的影响。
3.
A new technique that layer of carbon-bearing pellets is heated and direct reduced under conditon of parallel-flow heating with pre- heated air is put forword.
提出了一种顺流加热含碳球团直接还原的新方法。
5) ore/coal composite pellet
含碳球团
1.
The behavior of sulfur,sulfur distribution and methods of decreasing or controlling the sulfur content in iron bead have been investigated during the reduction and melting in ore/coal composite pellets in the coal hot-air rotary hearth furnace process(CHARP).
对转底炉煤基热风熔融炼铁工艺(CHARP)含碳球团还原熔分过程中硫的分配、硫的行为以及如何降低或控制珠铁中的硫含量进行了实验研究。
2.
The behaviour of reduction and melting in ore/coal composite pellets has been investigated experimentally at the high temperature electric resistance furnace.
通过高温电阻炉对含碳球团还原熔分的行为进行热态模拟研究,考察温度、配碳比、化学成分等因素对球团还原熔分的影响程度。
6) pellet containing carbon
含碳球团
1.
Based on the theory of Stefan flow, reduction mechanism of pellet containing carbon in oxidizing atmosphere has been studied and the minimum reduction rate vRL of pellet without oxidation may be calculated.
根据Ｓｔｅｆａｎ流理论，研究了含碳球团在氧化性气氛中的还原机理，建立了极限抗氧化还原速度ｖＲＬ的计算式。
补充资料：金属化纸和金属化薄膜
表面上蒸镀一层很薄 (0.1微米左右)的金属层的纸或薄膜。金属化纸曾应用于电缆、变压器作为屏蔽层,现多用于制造电容器。金属化纸和金属化薄膜的特点是具有自愈性,即当某处击穿时,短路电流使击穿部位周围的金属膜熔化并蒸发而又恢复绝缘性能，因此显著减少纸或薄膜中贯穿性导电疵点和弱点对击穿强度的影响，从而提高工作场强。低压纸介电容器如用铝箔极板（6～7微米）,必须用2～3层纸或薄膜,若用金属化纸或金属化薄膜,只要1层即可,极板的厚度也由6～7微米减少到0.1微米左右，大大节省材料。直流或脉冲电容器用金属化纸时，为了提高绝缘电阻，可以在纸的单面或双面涂以约1微米厚的快干纤维漆，然后在真空中蒸镀0.1微米的金属膜。交流电容器用的金属化纸或金属化薄膜，为了不使介质损耗增大，不喷漆，而是在纸或薄膜表面上直接蒸镀金属膜。用于蒸镀金属膜的金属有锌、镉、镍和铝等，以锌最适合（沸点较低）。有些薄膜（例如聚酯薄膜）可以先在表面上蒸镀银层，然后再蒸镀锌层。
金属化纸或金属化薄膜吸潮后，特别是在较高温度下容易被损伤腐蚀，在储存、加工过程中要采取适当的防潮措施。金属化纸一般不可用氯化物浸渍，以防止纸中析出的氢同氯化物浸渍剂析出的氯作用形成腐蚀性的氯化氢；但加了某些特殊的稳定剂后也可以用氯化物浸渍。
金属化纸或金属化薄膜吸潮后，特别是在较高温度下容易被损伤腐蚀，在储存、加工过程中要采取适当的防潮措施。金属化纸一般不可用氯化物浸渍，以防止纸中析出的氢同氯化物浸渍剂析出的氯作用形成腐蚀性的氯化氢；但加了某些特殊的稳定剂后也可以用氯化物浸渍。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条