1) viscosity retention rate
粘度保留率
1.
The polymer solution flows stably and evenly in the designed injection allocator, thus preventing mechanical shearing very well, reducing the viscosity loss of polymer solution effectively and ensuring the viscosity retention rate in the process of polymer injection.
聚合物溶液在所设计的配注器内的流动比较平稳,可很好地防止机械剪切作用,有效地减少了聚合物溶液的粘度损失,确保注聚过程的粘度保留率。
2) reserved adhesive rate
保留粘接率
3) strength retention rate
强度保留率
1.
Preparation of modified acrylic ester emulsion with monomer styrene(St),epoxy resin(WSR6101),diallyl phthalate(DAP),and their strength retention rate on fiberglass mesh was investigated in this study.
讨论了由苯乙烯(St)、环氧树脂(WSR6101)、邻苯二甲酸二烯丙酯(DAP)单体改性制得的丙烯酸酯乳液对玻璃纤维网布的强度保留率的影响,并通过FT-IR、光学显微镜等观测方式对树脂膜和玻璃纤维网布进行表面分析,表明在80℃的5%NaOH水溶液的作用下,树脂涂层发生了物理化学变化,同时碱液能够穿透树脂涂层并直接侵蚀玻璃纤维基体,导致粘接性能下降,从而降低了网布的机械强度。
4) viscosity retention ratio
黏度保留率
1.
The viscosity retention ratio of polymer solution sheared by WARING stirrer indicates that the highest viscosity retention ratio is polymer solution prepared by sewage,and when the sewage concentration is higher than 1 000 mg/L,viscosity retention ratio is about 90%.
结果显示:在相同浓度条件下,清污混合水配制的聚合物溶液黏度最高,其次是污水配制的聚合物溶液,水源水配制的聚合物溶液黏度最低;聚合物溶液经WARING搅拌器(1档3 500 rpm,20 s)剪切后的黏度保留率数据显示,污水配制的聚合物溶液剪切后黏度保留率最高,当浓度大于1 000 mg/L时,保留率在90%左右;最低的是水源水配制的聚合物溶液,保留率在55%左右。
5) viscosity retention in brine
盐水粘度保留值
6) Retention rate of tensile strength
拉伸强度保留率
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条