2) leather dyeing
皮革染色
1.
The results of the application and systemic tests showed that the reduction of the dyestuff amount, the increase in the dyeing fastness and the improvement of the dyestuff absorption could be found, when it was used in the leather dyeing.
通过在分子中引入羟基、氨基等官能团,合成了具有优良溶解性的阳离子分子,并将合成的产品应用于皮革染色,对应用效果进行了系统的检测,结果证明使用本产品之后可减少染料的用量,提高染料上染率和染色坚牢度。
2.
The effects of the reasonable use of a series dyeing assistants on leather dyeing were studied.
研究了皮革工业上广泛使用的一些染色助剂以及我们自主研发的APA匀染增艳剂、DA增深固色剂的合理使用对皮革染色的影响,重点考察了它们的匀染、增深、增艳和固色作用。
3.
In this paper, action mechanism on metal ion( Zr 4+ ) and black dyestuffs in leather dyeing was studied.
本文研究了金属离子Zr4+ 与皮革染色常用黑色染料的作用机理。
3) Colored leather
染色皮革
4) leather wastewater
皮革废水
1.
Removal ability of organics in leather wastewater by micro-filtration;
微滤法脱除皮革废水中有机物性能的研究
2.
Engineering design of leather wastewater treatment by UASB-Contact oxidation;
UASB-接触氧化处理皮革废水工程设计
3.
Influence of temperature and pH on the shortcut nitrosification of the leather wastewater was studied in a sequencing batch reactor(SBR),with the other factors steady.
在SBR反应器中,控制其他条件不变,研究温度和pH值对皮革废水进行短程硝化的影响。
5) tannery wastewater
皮革废水
1.
Advanced treatment of effluent of biochemical treated tannery wastewater by Fenton reagent;
Fenton试剂法深度处理皮革废水生化出水的研究
2.
Change of comprehensive toxicity of tannery wastewater through microelectrolysis-SBR treatment
皮革废水经微电解-SBR处理后的综合毒性变化
3.
Pretreatment of tannery wastewater by UV/Fe-EDTA/H_2O_2 process under alkaline conditions
碱性条件下UV/Fe-EDTA/H_2O_2预处理皮革废水
6) dyeing wastewater
染色废水
1.
Analysis of the pollutants in acrylic fabric dyeing wastewater;
腈纶织物染色废水的污染物分析
2.
Analysis of the treatment of dyeing wastewater from superfine fibre fabric;
超细纤维织物染色废水的处理与分析
3.
Treatment of dyeing wastewater by AO_1O_2 Process;
AO_1O_2工艺处理染色废水
补充资料:皮革刷浆
分子式:
CAS号:
性质:又称皮革刷浆。轻革涂饰的一种方法。指人工用毛刷蘸取涂饰色浆涂刷于革面的操作。同手工揩浆一样,工具简单,适应“看皮做皮”的凭经验操作特点。视皮的不同部位及紧密程度掌握施浆的均匀性。缺点是劳动强度大、工效低,现已有刷辊式涂饰机可选用。刷涂法适用于革的底层涂饰及树脂填充等。
CAS号:
性质:又称皮革刷浆。轻革涂饰的一种方法。指人工用毛刷蘸取涂饰色浆涂刷于革面的操作。同手工揩浆一样,工具简单,适应“看皮做皮”的凭经验操作特点。视皮的不同部位及紧密程度掌握施浆的均匀性。缺点是劳动强度大、工效低,现已有刷辊式涂饰机可选用。刷涂法适用于革的底层涂饰及树脂填充等。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条